672465

Edilkamin ANIA Manual

41
Zoom out
Zoom in
Previous page
1/192
Next page
- 43 -
ENGLISH
POSSIBLE TROUBLESHOOTING
6) Signalling: smoke °C/high.
Problem: turns off due to exceeding maximum smoke temperature.
Actions: • Check the pellet type
• Check for anomalies with the smoke-extraction motor
• Check to see if there are any obstructions in the smoke channel
• Check correct installation
• Gear motor faulty (CAT)
7) Signalling: Check button (signals an anomaly on the emergency button)
Actions: • check maintenance status of the button and its board connection cable (DEALER).
8) Signalling: “Battery check”
Problem: The insert does not stop but the error appears on the display.
Actions: • The buffer battery of the control board needs changing (DEALER).
Remember that this component is subject to regular wear and so it is not covered by the guarantee.
9) Signalling: ALARM - HIGH CURRENT: Activated when anomaNEAs, excessive current absorption is detected on the
gear motor.
Actions: Check functioning (CAT): gear motor - Electrical connections and electronic board.
10) Signalling: ALARM - LOW CURRENT: Activated when anomaNEAs, insuf¿ cient current absorption is detected on
the gear motor.
Actions: - Check functioning (CAT): gear motor - pressure switch - tank thermostat - electrical connections and elec-
tronic board
- Make sure that the two pellet hopper loading doors are tightly closed
11) Problem: Remote control not working
Actions: • Move closer to the stove
• check the battery and if necessary, replace it.
• Synchronisation with automatic search on activation: when you put the batteries into the radio control a
radio channel search phase will start up automatically, and it will subsequently connect to the product de-
tected. So that this occurs correctly, make sure to switch the product on before inserting the batteries in the
radio control, and stay in the vicinity of the antenna in order to achieve radio coverage with certainty.
• Synchronisation with automatic search and manual activation - it is possible to launch an automatic search
for a product manually, simply carry out the following operations after having already put the batteries into
the radio control:
- Go close to the product’s antenna and make sure it is connected to the electricity supply.
- With the display switched off (standby) hold the 0/I key down for 10”.
- After 10” a “NETWORK SEARCH” message appears on the display, then release the o/I key, as this means
that the automatic search has been activated.
- Automatic tuning of the radio channel will occur within a few seconds.
12) Problem: During ignition, the differential switch trips (DEALER):
Actions: • Check the condition of the ignition coil, the electrical system, and the electrical components.
13) Problem: Outgoing air not hot:
Actions: • Check that the fan is working.
NOTE 1
All signals/warnings remain shown until you intervene on the remote control, by pressing the button
.
Do not use the insert before having eliminated the problem.
NOTE 2
Once 1000 kg of pellets have been consumed or some other value set by the CAT during the ¿ rst ignition, the display
À ashes a message that reads “maintenance”.
The stove works, but you must call the Dealer out to perform extraordinary maintenance.
NOTE 3
solid-fue due to the quality of pellets or particularly critical installation, the stove becomes clogged earlier, the message
“CALL SERVICE” will appear. Proceed as per “Mainten.” instructions.
N.B.:
The combustion chambers and smoke ducts connected to the solid-fuel appliances must be cleaned once a year (check
if your country has speci¿ c legislation covering this).
Failure to regularly check and clean increases the likelihood of a ¿ re in the chimney pot.
IMPORTANT!!!
In the case of a ¿ re in the stove, in the À ue or in the chimney, proceed as follows:
- Disconnect the power supply
- Use a carbon dioxide (CO
2
) extinguisher
- Call the ¿ re brigade
DO NOT ATTEMPT TO PUT THE FIRE OUT WITH WATER!
After the event, have the appliance checked by an authorised Service Centre and have an authorised technician check the À ue.
… 41 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin ANIA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin ANIA in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info