672465

Edilkamin ANIA Manual

31
Zoom out
Zoom in
Previous page
1/192
Next page
- 33 -
ENGLISH
A: À ue in insulated steel compliant with EN 1856
B: minimum height of 1.5 m and in any case above the height of the
roof gutter
C-E: air intake from inside room (minimum internal section: 80 cm²)
D: steel À ue, inside existing brick-built chimney.
SMOKE OUTLET
The stove must have its own smoke outlet (the smoke can-
not be discharged into a smoke À ue used by other devices).
The smoke is discharged through the 8 cm diameter outlet at
the back
of the stove
.
The smoke outlet must be connected to outside by means of
suitable steel pipes EN 1856 certi¿ ed.
The pipe must be hermetically sealed.
An example of a suitable pipe bears the following
information:T600 N1 D V2 L50050 G70 (not suitable with T <
200; 0 indicating no resistance to the À ow of soot).
The material used to seal and if necessary insulate the pipes,
must be resistant to high temperatures (high temperature silico-
ne or mastic).
The only horizontal section allowed may be up to 2 m long up
to three 90° bends (in relation to the vertical).
A vertical section of at least 1.5m and an anti-wind terminal
is necessary (if the discharge outlet is not in a chimney À ue -
reference UNI 10683).
The vertical duct can be internal or external.
If the smoke channel is outside, it must be appropriately insu-
lated. If the smoke channel is ¿ tted inside a chimney À ue, the
latter must be suitable for solid fuel.
If it is wider than 150 mm in diameter it must be improved by
entering a pipe that has a suitable cross-section and is made of
suitable material (e.g. 80 mm diameter steel).
All sections of the smoke duct must be accessible for inspec-
tion.
The chimney pots and smoke ducts connected to the solid fuel
appliances must be cleaned once a year (verify whether a speci-
¿ c legislation exists in your country).
Failure to regularly inspect and clean the stove increases the
probability of a ¿ re occurring in the chimney pot. In that case,
proceed as follows: Do not use water to extinguish the ¿ re;
Empty the pellet hopper; Contact specialist personnel before
reigniting the stove.
The stove is designed to work under any weather conditions.
In case of particular conditions, such as strong wind, the safety
system may be activated, which results in the stove being extin-
guished.
If this happens, do not operate the stove with the safety devices
disabled. If the problem persists, contact our Technical Service
Department.
INSTALLATION
CHIMNEY POT
The main characteristics are:
- an internal cross-section at the base, which is the same as that
of the chimney À ue
- an outlet cross-section which is no smaller than twice that of
the chimney À ue
- its position must be high enough to catch the wind and avoid
downdraft areas in turbulent wind, it must be high enough to
catch the wind and avoid downdraft areas in turbulent wind.
TYPICAL EXAMPLES
Fig. 1 Fig. 2
54
111
11
34
54
54
54
111
42
13
54
111
11
34
54
54
54
111
42
13
inspection
… 31 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Edilkamin ANIA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Edilkamin ANIA in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 4,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info