663881
10
Zoom out
Zoom in
Previous page
1/12
Next page
SUGGESTIONS
1. Because of the ultra fine diamond abrasives used in this sharpener, it is extremely
important to always clean all food, fat, and foreign materials from the knife before
sharpening or resharpening. If knife is soiled, wash it thoroughly before sharpening. If
food, oil or fats accumulate on the ultrafine diamonds of Stage 2 you will notice that it will
sharpen more slowly. In that event unplug the power cord from electrical socket, remove
the gray plastic spring marked #2 which is held in place by two black plastic “spring-pins”.
Use a small screwdriver to slip under the back of the plastic spring and pry it up until it is
loose. Remove the plastic spring. Save the spring and spring-pins and clean the Stage 2
diamond disks. To clean the disks use a small children’s toothbrush and a weak solution of
household dish detergent (such as Dawn). Prepare a solution of about 2 drops of detergent
in a cup of warm water. Place only a few drops of detergent solution on brush and scrub
the sharpening faces of the disks. Rotate the disks by hand to brush all areas of the disks
several times. Then rinse lightly with water on the brush. Always use a brush and minimize
the amount of water used. Cut a small piece of paper towel to pat the disks dry. Allow time
for disks to dry completely and be certain no water remains in sharpener before turning on
power. Reassemble the plastic spring and fasten in place with the two plastic spring-pins.
2. To increase your proficiency with the Chef’sChoice
®
Model 312, take the time to learn how
to detect a burr along the edge (as described on p. 7). While you may sharpen well without
using this technique, it is the best and surest way to determine when you have sharpened
sufficiently in Stage 1. This will help you avoid oversharpening and insure sharp edges
every time. Cutting a tomato or a piece of paper is a convenient method of checking for
blade sharpness when sharpening is finished.
3. Use only light downward pressure when sharpening – just enough to establish secure
contact with the abrasive disk.
4. Always pull the blades at the recommended speed and at a uniform rate over length of
blade. Never interrupt or stop the motion of the blade when in contact with the abrasive
disks.
5. Always alternate individual pulls in right and left slots (of any Stage used). Specialized
Japanese blades are an exception and are sharpened primarily on one side of the blade.
6. The edge of the knife blade while sharpening should, in general, be held in a level position
relative to the top of the counter or table. However, to sharpen the blade near the tip of
a curved edge, lift the handle up slightly but just enough to maintain the edge audibly in
contact with the abrasive disk.
7. There is no need or advantage to using a “sharpening steel” on knives sharpened on the
Chef’sChoice
®
Model 312. It is recommended that you keep the Model 312 readily acces-
sible and resharpen often, as described in the previous Sections.
10
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EdgeCraft Chef-s Choice 312 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EdgeCraft Chef-s Choice 312 in the language / languages: English as an attachment in your email.

The manual is 0,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info