547014
15
Zoom out
Zoom in
Previous page
1/23
Next page
15
Internal connection External wired connection
DIP 1: ON
DIP 2: OFF
Only the internal contact will be
active.
DIP 1: OFF
DIP 2: ON
Only the external contacts will be
active.
DIP 1: ON
DIP 2: ON
Both contacts will be active. (Both
contacts must be all close, the
Detector will then be treated as close;
if one of the contacts is open, the
Detector will be treated as open.)
DIP 1: OFF
DIP 2: OFF
Only the internal contact will be
active.
Note: Remove batteries before setting the SW2. Refit
batteries after setting the SW2.
3. In order to communicate with the Control Panel,
the ID code of the Detector needs to be learned by
the Control Panel. By pressing the tamper switch
located at the rear cover of the Detector will emit
the ID code to the Control Panel instantly, subject
to the Control Panel being set at the ID code
learning mode.
TESTING THE DOOR/WINDOW CONTACT
DETECTORS
Ensure the system is in test mode.
1. Detach or close the magnet from the Detector, the
Control Panel will ding dong to indicate that the
alarm signal has been received.
2. Press to exit test mode.
FACTORY DEFAULTS
Disarm Mode Disarm
User Access Code 1 2 3 4
Key Tone On (enable)
Activation Type 1 Siren/Dialer enable
Alarm Duration 1 minute
Jamming Detection Off (disable)
Entry Delay 15 sec
for arm/part-arm
Off (disable)
SETTING
Q. Dip Switch
R. Jumper Link
JUMPER LINK
Setting Jumper link into the ON position will reset all of
the settings to factory default, such as all of ID codes,
phone number and alarm message.
DEFAULT
RESET
TOP VIEW
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eden HA700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eden HA700 in the language / languages: English as an attachment in your email.

The manual is 1,95 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eden HA700

Eden HA700 User Manual - German - 29 pages

Eden HA700 User Manual - French - 29 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info