660277
30
Zoom out
Zoom in
Previous page
1/68
Next page
[
ECTIVE
®
SINUS/SINE INVERTER – CSI-/SSI-SERIES
]
28
Fehler selbst beheben
Symptom mögliche Ursache Lösung
WR eingeschaltet
Status-LED leuchtet
nicht
Kein akustisches Signal
Keine
Ausgangsspannung
Es liegt keine Spannung
am Eingang an.
1. Überprüfen Sie die
Batteriespannung
2. Überprüfen Sie die Ein-
gangssicherungen
3. Überprüfen Sie alle Ver-
bindungen zur Batterie
Durchgebrannte Sicherun-
gen durch Verpolung
(Achtung: eine
Verpolung kann trotz
Sicherung zur
Beschädigung des WR
führen)
Tauschen Sie die durchge-
brannten Sicherungen aus
und schließen die Kabel
richtig an.
Sollte der WR nach dem
Tausch nicht funktionie-
ren, wurde er vermutlich
beschädigt.
Rufen Sie den Support
an!
Akustisches Signal tönt
einmalig auf.
1. Verbindung zu Verbrau-
chern abgerissen
2. Kurzschluss an Verbrau-
chern
1. Verbindung über prüfen
2. Auf Kurzschluss über-
prüfen
Akustisches Signal ertönt
2x und
rote LED blinkt 2x
alle 8 Sekunden
Drohende Unter spannung
erreicht
(siehe Tabelle)
1. Ladestand der Batterie
prüfen, ggf. Nachladen
2. Batteriekabel auf Kom-
patibilität prüfen, ggf.
höhere Quer schnitte
verwenden
3. Leitende Teile(z.B.
Kabel, Polklemmen, Ka-
belschuhe) auf Beschä-
digungen überprüfen.
30


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ective Energy CSI104 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ective Energy CSI104 in the language / languages: English, German as an attachment in your email.

The manual is 0,75 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info