668120
34
Zoom out
Zoom in
Previous page
1/40
Next page
Dust sensor cleaning
The dust sensor is located at the front of dust
entrance. It is able to detect the concentration of
dust so that it can choose efficient mode to work.
We suggest you to clean dust sensor once you
clean dust box to improve work efficiency.
1. Turn off power.
2. Take out dust box and clean it.
Enj o y Sma r ter L i fe!
34
Replacing the batteries
Your Robot is fitted with two 6V 2500mAah Ni-MH battery packs. The battery packs must be replaced together.
Never mix an old Battery pack with a new Battery pack.
Only use ECOVACS approved replacement parts for your Robot. Use of parts that are not approved by
ECOVACS are dangerous and will invalidate your warranty.
Before attempting to change the Batteries, make sure your Robot is turned Off.
Turn your Robot over and
place it on a level surface.
Remove the screw from the
Battery cover.
Remove the Battery cover. Disconnect the old Battery by
removing the Battery
connector from its socket.
Using the battery leads, lift
the old Battery pack from the
Battery compartment.
When fitting the new
Batteries, strict attention
must be paid to the polarity of
the Battery pack connector:
Red - positive (+)
Black - negative (-)
Connect the new Battery to
the socket. Carefully lower
the Battery pack into the
Battery compartment. Refit
the Battery cover and tighten
Battery cover screw.
Note: Repeat the steps above to replace the second Battery pack.
Yellow
Yellow
Black
Red
34


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ecovacs Deebot D76 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ecovacs Deebot D76 in the language / languages: English as an attachment in your email.

The manual is 5,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info