506246

EcoCare GC3720 stoomstrijkijzer Manual

19
Zoom out
Zoom in
Previous page
1/24
Next page
19
Problem Possible cause Solution
EN The iron does not produce
steam.
The steam position is set to 0.
Set the steam position to l or ;.
The iron leaks Thewatertankislledbeyond
its capacity
Donotllthewatertankbeyondthe‘MAX’
symbol.
The steam boost function does
not work properly.
You have used the steam boost
function too often with not
enough intervals.
Temporarily keep the iron horizontal before you
use the steam boost function again.
Flakes and impurities leak from
the soleplate during ironing.
Hardwaterformsakesinside
the soleplate.
Usethecalc-cleanfunctionuntilallakesand
impurities have been disposed of.
Water spots appear on the
garment during ironing.
Steam has condensed onto the
ironing board.
Occasionally iron wet spots without steam in
order to dry them.
If the underside of the ironing
board is wet, wipe it dry with a
piece of dry cloth.
To prevent steam from condensing onto the
ironing board, use an ironing board with a wire
mesh top.
Problem Mulig årsag Løsning
DA
Strygejernet producerer ikke
damp.
Dampvælgeren er indstillet til 0.
Indstil dampvælgeren til l eller ;.
Strygejernet lækker. Vandtanken er overfyldt. Fyld aldrig vandtanken til op over MAX-symbolet.
Dampskudsfunktionen fungerer
ikke optimalt.
Du har brugt dampskudsfunk-
tionen for ofte for hurtigt efter
hinanden.
Hold strygejernet vandret midlertidigt, før du
bruger dampskudsfunktionen igen.
Der drysser små kalkpartikler
og urenheder ud fra strygesålen
under strygning.
Hårdtvanddannerkalkaejringer
inde i strygesålen.
Brug Calc-Clean-funktionen, indtil alle
kalkpartikler og urenheder er væk.
Der kommer vandpletter på
stoffet under strygning.
Dampen har dannet kondens på
strygebrættet.
Stryg våde pletter fra tid til anden uden damp
for at tørre dem væk.
Hvis undersiden af strygebrættet
er våd, kan du tørre den med en
tør klud.
Hvis du vil undgå, at der dannes kondens på
strygebrættet fra dampen, kan du bruge et
strygebræt med et trådnetsunderlag.
Problem Mögliche Ursache Lösung
DE
Das Bügeleisen erzeugt keinen
Dampf.
Die Dampfposition ist auf “0”
eingestellt.
Stellen Sie die Dampfposition auf l oder ; ein.
Aus dem Bügeleisen läuft
Wasser aus.
Der Wasserbehälter wurde über
seine Kapazität hinaus gefüllt.
Füllen Sie den Wasserbehälter nicht über die
Markierung MAX hinaus.
Die Dampfstoß-Funktion
funktioniert nicht einwandfrei.
Sie haben die Dampfstoß-
Funktion zu oft in zu geringen
Zeitabständen verwendet.
Halten Sie das Bügeleisen kurze Zeit
waagerecht, bevor Sie die Dampfstoß-Funktion
wieder verwenden.
Kalkpartikel und Verunreini-
gungen treten während des
Bügelns aus der Bügelsohle aus.
Durch hartes Wasser bilden sich
Kalkpartikel in der Bügelsohle.
Verwenden Sie die Calc-Clean-Funktion, bis
alle Kalkpartikel und Verunreinigungen entfernt
wurden.
Während des Bügelns
erscheinenWassereckenauf
dem Kleidungsstück.
Dampf ist auf dem Bügelbrett
kondensiert.
Bügeln Sie hin und wieder über feuchte Stellen,
um sie zu trocknen.
Falls die Unterseite des
Bügelbretts nass ist, wischen Sie
sie mit einem trockenen Tuch ab.
Um zu verhindern, dass sich Dampf auf dem
Bügelbrett niederschlägt, verwenden Sie ein
BügelbrettmiteinerOberächeaus
Drahtgeecht.
4239_000_7878_1_DFU-Booklet_A5_v1.indd 19 13-05-11 09:17
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for EcoCare GC3720 stoomstrijkijzer at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of EcoCare GC3720 stoomstrijkijzer in the language / languages: Dutch as an attachment in your email.

The manual is 4,51 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info