647412
19
Zoom out
Zoom in
Previous page
1/53
Next page
ENGLISH
Instruction manual CLASSIKA
19
4 MACHINE INSTALLATION
4.1 Preparation for the installation
Place the machine on an even and stable surface. You can regulate the height of the machine by
adjusting the feet of the machine.
Never place the machine on hot surfaces.
4.2 Electrical connection
Make sure that the local main supply voltage corresponds to the information given on the type plate
on the front panel of the espresso machine.
Plug the machine only into an earthed socket and do not leave it unattended.
Do not roll or bend the power cord.
Do not use an extension cord/ do not use a multiple socket.
5 FIRST USE
5.1 First use
Read the instruction manual carefully before operating the machine.
Before starting the machine, check if:
the steam/ hot water valve is closed.
the machine is switched off. (Power switch in lower position.)
the power cord is disconnected.
the drip tray is inserted accurately.
Now you can begin to operate your machine:
1 Remove the cup heater tray.
2 Fill the water tank with fresh water, deficient in lime. Replace the cup heater tray.
3 Insert the plug in the wall socket. Turn the power switch in upper position. The machine is now on.
Important!
Also for the first use, the boiler has to be filled.
4 Place a small container (e. g. a milk jug) under the steam/ hot water valve. Open the steam valve by turning it
anticlockwise and move the pump/ hot water switch into the upper position. A pump sound should be audible.
Now the boiler fills with water. At first use, it can take a few seconds before the water comes out of the steam
valve. Please allow that approx. 600 ml of water come out of the valve. In this way, the boiler is flushed and
filled with fresh water. This allows you to constantly renew the boiler water in daily use. Switch off the pump/
hot water switch by moving it into the lower position and close the steam/ hot water valve.
5 Dispense water by moving the group lever into the upper position. Then put back in lower position.
6 The machine heats up and the orange control lamp for heating control lights up.
7 As soon as the optimum temperature (approx. 110-120 °C) is reached, the heating shuts off automatically and the
control lamp for heating control goes out. The indicator of the pump pressure gauge may move slightly during the
heat-up phase.
8 Clamp the empty filter holder to the brewing group to preheat filter and filter holder. You can accelerate this
process by dispensing water from the brewing group.
9 For the first filling-up of the boiler, a large amount of water is required. Therefore, refill the water tank with water
after the first use.
10 The machine is now ready for use. Put the cups on the cup heater tray in order to preheat them. Then enjoy your
coffee!
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ecm Classica II at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ecm Classica II in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 1,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info