-
9
-
Deutsch Español Français Italiano
Nederlands
SvenskaEnglish
-
Using the splicing connector
-
Insert the connection cable [vehicle speed pulse signal
cable (purple/white), parking brake cable (red/white),
or reverse cable (green)] from the main unit and the
vehicle cable into the splicing connector.
1
Harness in the car
7
Press down the cover of the splicing connector and
squeeze it until it locks.
2
Lock
7
Attach a splicing
connector at this location
Reverse signal cable
Reverse lamp
Reverse signal cable
-
Connecting point for the reverse signal (example)
-
•
Be sure to connect the reverse signal cable. If it is not
connected, the vehicle position may be incorrect when
the vehicle is reversed.
•
Use a circuit tester to confirm that a sensing voltage of
6 V or higher is generated when the vehicle is reversed.
Tip
Use a splicing connector to connect the reverse signal
cable (green) coming from the main unit to the reverse
signal cable of the vehicle.
1
Route the reverse signal cable to the main unit .
2
Vehicle speed pulse signal cable
(purple/white), parking brake cable
(red/white), or reverse cable (green)
