424454
5
Zoom out
Zoom in
Previous page
1/16
Next page
Receiver description
Safety information
Section 1
DSB-2220 2Ci Page 1 - 1
© 2003 EchoStar International Corporation
All rights reserved
English
1
SAFETY INFORM ATION
1. GENERAL SAFETY
Read this manual carefully and make sure you understand the instructions given. For your
safety, know what the reaction upon each action will be. Do not perform any actions which are
not described in this manual, failing to do so might result in an uncontrolled behavior of the
receiver or even in a hazardous situation for persons and/or equipment.
Disconnect the receiver from the mains before you start any maintenance or installation
procedures. Do not use alcohol or ammonia based liquids to clean the receiver. If required,
clean with a soft lint-free cloth slightly made damp with a mild soap solution.
Consult an authorized service technician if the receiver does not operate normally when the
instructions in this user manual are strictly followed. Do not to attempt to open the receiver, as
you will be exposed to a shock hazard.
To avoid the risk of electrical shock and fire, do not put any objects on top of the receiver
which:
contain liquids, such as vases, glasses, bottles, etc.
contain an open heat source or open fire, such as candles, cigarettes, ash trays, etc.
could fall through the ventilation slots or which could cover them and prevent proper
cooling of the components inside.
Make sure that nothing rests on the receivers cables and that the cables are not located
where they can cause injury to persons and pets (e.g to stumble over, eat the cable).
Do not install the receiver:
in a closed or poorly ventilated cabinet;
directly on top of or under another equipment;
on a surface which will obstruct the ventilation slots.
Do not expose the receiver and it’s accessories:
to rain or excessive moisture to avoid the risk of shock or permanent damage to your
receiver;
to direct sunlight, heaters, stoves or any other heat generating equipment;
to any magnetic objects, such as speakers, electric motors, transformers, etc.;
to excessive vibration.
To help avoid possible damage to the receiver’s electronics:
wait 5 seconds after you switched off the receiver before you move the receiver or
disconnect any equipment
Do not put any foreign objects into the CI-slots.
do not touch the components or pins on the CI-module or the Smartcard and hold the
CI-module and the Smartcard by it’s edges.
2. ELECTRICAL SAFETY
When you use or connect electrical equipment, always obey the safety regulations as
applicable in your country, to reduce the risk of fire, electrical shock and personal injury.
Read and comply at least with the given safety instructions.
Do not put any (foreign) objects into the ventilation slots. This can cause fire or an
electrical shock by shorting the internal components.
Always make sure that the electrical power supply corresponds with the voltage on the
electrical identification plate at the rear of the receiver next to the electrical cord.
Your receiver is double insulated in compliance with the standards as stated in the
EC Declaration of Conformity; therefore no additional earth wire is required, though the
use of an earth leak switch and/or over voltage protection switch is recommended.
Only use an approved extension (convenience) lead suitable for the electrical power
consumption of the installed equipment.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Echostar dsb 2220 2ci at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Echostar dsb 2220 2ci in the language / languages: English as an attachment in your email.

The manual is 0,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info