782631
12
Zoom out
Zoom in
Previous page
1/16
Next page
CE-L10 English
English CE-L10
Phone: 866-356-1992 | Email: Support@eccotemp.com Phone: 866-356-1992 | Email: Support@eccotemp.com
PLEASE NOTE: THIS MODEL IS NOT RECOMMENDED NOR HAS IT BEEN TESTED FOR ANY PERMANENT INSTALLATIONS. THIS MODEL
IS PART OF OUR PORTABLE SERIES AND NEEDS TO BE TAKEN DOWN AND STORED IN A WARM DRY PLACE AFTER EVERY USE.
THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT NOTICE.
12 13
Support: Eccotemp.com/help-desk Shop Online: eu.eccotemp.com/products Store Locator: Eccotemp.com/locatorSupport: Eccotemp.com/help-desk Shop Online: eu.eccotemp.com/products Store Locator: Eccotemp.com/locator
Portable tankless water heater will not start – there are no audible clicks at startup:
a. The rst thing to check is to ensure that the incoming water on the “right” side of the portable
tankless water heater. If the incoming and outgoing are reversed, the portable tankless water heater
will not work. The incoming is on the far right and the outgoing is in the middle.
b. Check to make sure you have fresh batteries and they are installed in the correct position.
c. Number one reason that the portable tankless water heater does not ignite is that there is not
enough water pressure. You need a minimum of 10 PSI / 0.7 bar, sustained. Municipal water should
supply enough water pressure. Most 12/18/120/240 pumps well as long as they are capable of
delivering pressure of 10 PSI / 0.7 bar or greater.
ADJUSTMENT: Looking up at the bottom of the portable tankless water heater, you will see two “slits”
in the case where the front and back come together. Locate the water regulator where you will see
two Phillips head screws. Take the screw that is furthest on the right (larger screw) in about a ¼ or
½ turn. This will enable the portable tankless water heater to operate on a lower water pressure by
restricting ow.
NOTE: Before attempting to remove the cover, call technical support at the number on page 11.
d. A wire has become disconnected inside the portable tankless water heater during shipping. Make
sure the gas is OFF. The front cover is held by six screws, four on top, two on bottom. The knobs pull
o. All the wiring is done with push together plastic connectors. They are all visible without further
dismantling of the portable tankless water heater. It should be obvious when a wire has become
disconnected.
e. It is possible that some debris or epoxy might have entered the water regulator. Check to see if the
lter screen on the water inlet is clear of debris. You can also reverse the hookup by taking your water
source and hooking it up to the water outlet side and back ushing the system.
f. Propane gas cylinders sometimes are contaminated with air, especially new tanks upon their rst
lling. Cycle the portable tankless water heater turning o and on your output ow or similar. Does
not include a shower head.
Should a portable tankless water heater fail to light or stay lit after 10 cycles, please visit our helpdesk
located at gb.eccotemp.com for additional troubleshooting steps.
Portable tankless water heaters starts, then shuts o:
a. If the Rain cap is blocked, or not long enough, the portable tankless water heater will shut o after
a few minutes.
b. The portable tankless water heater requires a minimum of about 0.75 gallons per minute (2 liters)
and a minimum of about 20 PSI / 1.4 bar. Note: water pressure is at the lower end of operating
parameters. You will need a sustained water pressure of approximately 40-60 PSI / 2.7-4.1 bar for
adequate use if you are using a 12/18/120/240 volt pump. See ADJUSTMENT in previous section
above.
DO NOT RETURN TO STORE
Troubleshooting
Please contact us via the technical support information on page 14 if you
have any problems.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Eccotemp CEL10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Eccotemp CEL10 in the language / languages: English as an attachment in your email.

The manual is 3.3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Eccotemp CEL10

Eccotemp CEL10 User Manual - German - 18 pages

Eccotemp CEL10 User Manual - Dutch - 18 pages

Eccotemp CEL10 User Manual - French - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info