611869
7
Zoom out
Zoom in
Previous page
1/24
Next page
Receiver - Micro Appliance Modules Ref : RMML
July 2009 page 7 RMML
Do not connect more lights as the total permitted amount of wattage allows.
1. CAUTION: Shut off power to the circuit in the electrical panel.
2. With the aid of a screwdriver press on the top of the terminal board and
insert the cables (for the light xture see diagram 1, for the power socket see
diagram 2). Then verify the connections by pulling lightly on the wires.
3. Pull out the antenna as far as you can for better reception.
PROGRAMMING
The Micro Transmitter commands must be recognized in order to add the Micro
Receiver to a different installation from the original or to one with interference
from a nearby system.
1. Proceed to make a “Reset”. Press down and hold the button in the (PROG)
opening with a paper clip until the LED lights up GREEN, then release it. The LED
should ash YELLOW: the Micro Receiver now has no code.
2. With the paper clip, press down briey in the (PROG) opening. The LED will
ash GREEN and wait for a command from a Micro Transmitter or remote control
switch.
3. Press one of the buttons on the Micro Transmitter or the remote control switch:
the Micro Receiver LED will stop blinking, conrming it has received the command.
The programming is done!
REMARKS
The RMML Micro Receiver will remember as many Micro-Transmitters and remote
control switches as necessary.
VERIFICATION
Verify On/Off switch operation.
You must wait about a second between each On / Off command.
When changing the battery, the registered code will be retained by the Micro
Transmitter.
Troubleshooting - please check FAQ and technical support on
www.ebodeelectronics.eu
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ebode RMML at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ebode RMML in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish, Norwegian as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info