611769
7
Zoom out
Zoom in
Previous page
1/76
Next page
31-7-2014 7 ebode IPV58P2P
1. I/O alarm terminal block (Not available for this camera)
This network camera provides a I/O alarm terminal block which is used to connect to
external input / output device. The pin(there are four number in the terminal block from
no. 1 to no. 4) definitions are as follows: 1.) input, 2). input, 3). output, 4). output.
This camera supports I/O alarm, you can go to Settings-Alarm - I/O page to configure it.
2. LAN
10/100M adaptive Ethernet interface. Through this interface, IPCAM can be connected
with various network devices, such as hub, router, etc.
3. Reset Button
Press and hold on the reset button for 5 seconds. Releasing the reset button, the
password will back to the factory default administrator password. The default
administrator user is admin with no password.
4. Power Interface
Connect the external power adapter, request for 12V/2A power.
5. Audio input interface
The jack is used to plug external input device such as sound pick up device directly. Here
microphone cannot directly insert to the interface, it must connect to commutator first.
6. Audio output interface.
The jack is used to plug external output device such as loud speaker directly. Here
microphone cannot directly insert to the interface, it must connect to commutator first.
7. RS486 Cradle head interface (Not available for this camera)
This camera supports the standard 485 cradle head protocol (Pelco-D and Pelco-P).
Please configure the RS485 protocol corresponding information first (go to Settings- PTZ
- RS485 Configuration page and do settings), or else the cradle head may cannot work.
Bottom View
There are up to three labels located at the bottom of the camera; this is an important
feature of original cameras. If your camera does not have labels as shown in Figure 3.3
and 3.4, it may be a clone. Cloned cameras cannot use original firmware and are not
eligible for warranty or technical services.
Figure 3.3
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ebode IPV58P2P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ebode IPV58P2P in the language / languages: English as an attachment in your email.

The manual is 2,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info