Manual Easymaxx Z05837 (page 4 of 8) (English, German, Dutch, French)

703745

Zoom out

Zoom in

1/8

EN Instructions

Customer Service / Importer:

DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •

✆ +49 38851 314650 *)

*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.

■ Do not use corrosive or abrasive cleaning products to clean the

product. They could damage the surface. When needed, wipe

the product off with a soft, dry cloth.

Product contents

• 1 x daylight lamp with built-in control panel

• 1 x adapter

• 1x remote control including 3 V type CR2032 button cell

(inserted)

Remote control

1 AN/AUS switch (ON/OFF)

2 Warm white light

3 Tageslicht (daylight)

4 Farbe (colour)

5 Farbwechsel (colour

change), all colours

6 Control panel for colour

selection (12 mixed col-

ours)

7 RGB setting (red, green,

blue)

8 Increase/decrease the

brightness

Start-up

ATTENTION!

■ The plastic foils and bags pose a suffocation hazard! Keep

children and animals away from the packaging material.

• Unpack the product contents and make sure that they are

complete (see chapter “Product contents”) and check for any

damages from transport. If the product, plug or mains cord

exhibits damages, do not use the product (!); instead contact

customer service.

• Before you use the product, remove all packaging material and

any labels located on the product and which serve to provide

protection during transport or are for advertising purposes.

Changing the remote control battery

The battery for the remote control has already been inserted.

You only have to remove the transport guard.

1. The battery compartment is lo-

cated on the narrow side of the

remote control. Pull it out as

shown.

2. Remove the empty battery

and insert a 3 V battery (type

CR2032). The positive terminal

must point upwards.

3. Place the battery compartment back in the remote control so

that it locks in place.

Use

Please note that the colour settings are mixed colours. For

this reason, the colour tints may exhibit minor deviations.

1. Connect the adapter to the port in the base of the lamp.

2. Insert the mains plug in a properly installed socket that is easily

accessible.

3. Turn on the lamp by pushing the button AN (on) on the remote

control or ☼ An/Aus (On/Off) on the control panel of the lamp.

4. Select the desired colour. To do so, push the colour button (4)

ﬁ rst and then the corresponding colour button on the remote

control.

5. You can also select the desired effect and push the

corresponding button (2, 3, 5) on the remote control or push the

button M (mode) on the control panel of the lamp several times.

6. Set the desired colour brightness using the buttons to

increase / decrease the brightness on the remote control or

using the arrow buttons (˄ increase, ˅ decrease) on the control

panel.

7. Push the button AUS (off) on the remote control or push ☼ An/

Aus (On/Off) on the control panel again to turn off the lamp.

Troubleshooting

If the product is not working properly, please check whether you

are able to rectify the problem yourself.

Do not attempt to repair a defective electrical product

yourself!

If the light does not switch on, check

• whether the product is properly connected with the socket.

• whether the socket is defective. Try another socket.

• the fuse for your mains connection.

• whether the battery in the remote control is empty.

Variations

Article number Model number

wood look oak Z 05797 SL7375O

wood look brown Z 05811 SL7375M

wood look beech Z 05818 SL7375B

brass look Z 05825 SL7375C

chrome look Z 05837 SL7375N

white Z 07375 SL8025T

Technical data

Colour temperature:

warm white: approx. 3000 K

daylight: approx. 5500 K

Voltage supply:

adapter input: 100 – 240 V, 50/60 Hz

output: DC 12 V, 1 A

lamp: DC 12 V

remote control: 3 V (1 x 3 V battery, type CR2032)

Output: 5 W

Disposal

The packaging material is recyclable. Dispose of the

packaging in an environmentally-friendly manner and make

it available to the collection service for recyclable materials.

Dispose of the product in an environmentally-friendly

manner. It does not belong in the household garbage.

Dispose of it at a recycling centre for old electric and

electronic equipment. For more information, please contact

the administration in your community.

Batteries and rechargeable batteries must be removed and

disposed of separately before disposing of the product.

To protect the environment, batteries and rechargeable

batteries may not be disposed of together with normal

household waste. Instead they must be turned in at

appropriate collection points. Please also observe applicable

statutory provisions regulating the disposal of batteries.

push

pull

DLTL_V2_06_2016

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Easymaxx Z05837 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,23 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Easymaxx Z05837 Manual

Product: