Manual Eagle SeaCharter 642cDF iGPS (page 38 of 196) (English)

522017

Zoom out

Zoom in

1/196

Make sure the location does not interfere with the boat's trailer. Usually,

the sensor is mounted about one foot to the side of the transom's center-

line.

Once you have determined the proper location for the unit, place the

sensor on the transom. The bottom of the bracket should be flush with

the hull's bottom. Using the sensor as a template, mark the hull for the

screw's pilot holes. Drill four 1/8" holes, one in each end of the slots.

Mount the sensor to the hull using #8 stainless steel wood screws (not

included). Use a high quality, marine grade above- or below-waterline

sealant to seal the screws. Make sure the sensor is flush with the bot-

tom of the hull and tighten the screws.

Stern view showing good location for mounting sensor on transom.

If the base of the transom has a radius, fill the gap between the tran-

som and the sensor with the sealant. This will help ensure smooth wa-

ter flow.

Speed sensor mounting configuration:

side view (left) and rear view (right.)

Route the sensor's cable through or over the transom to the sonar unit.

If you need to drill a hole in the transom to pass the connector through,

the required hole size is 5/8".

Caution:

If you drill a hole in the transom for the cable, make sure it is lo-

cated above the waterline. After installation, be sure to seal the

hole with the same marine grade above- or below-waterline seal-

ant used for the screws.

Good location

Transom

Bottom of hull

www.Busse-Yachtshop.de email: info@busse-yachtshop.de

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eagle SeaCharter 642cDF iGPS in the language / languages: English as an attachment in your email.

The manual is 6,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eagle SeaCharter 642cDF iGPS Manual

Product: