Manual Eagle FishMark 320 Fishfinder (page 25 of 92) (English)

469086

Zoom out

Zoom in

1/92

100 grit sandpaper. The surface of the hull must be flat so the entire

transducer face is in contact with the hull prior to bonding.

Epoxy transducer to hull.

2. Follow the instructions on the epoxy package and mix it thoroughly.

Do not mix it too fast, because it will cause bubbles to form in the ep-

oxy. Apply a small amount on the face of the transducer as shown

above, then spread a small amount onto the sanded area on the hull.

Place the transducer into the epoxy, twisting and turning it to force

any air bubbles out from under the transducer face. The face of the

transducer should be parallel with the hull, with a minimum amount

of epoxy between the hull and transducer. After the epoxy dries,

route the cable to the sonar unit.

Speed/Temperature Sensors

This unit can accept as many as two temperature sensors, which can be

used to monitor the temperature of surface water, a live well or some

other location. These units can also accept an optional speed sensor for

showing speed and distance traveled. However, you can only use one ac-

cessory at a time. If you would like to use a speed sensor and a second

temperature sensor at the same time, you will need a combination device.

NOTE:

This unit is packed with a transducer containing a built-in temp sen-

sor. The SeaFinder package also includes a speed sensor. If you have

a FishMark 320 and want a speed sensor or additional temp sensor,

see the Accessory Ordering Information in the back of this manual.

Spread epoxy here

Sand this surface

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eagle FishMark 320 Fishfinder in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eagle FishMark 320 Fishfinder Manual

Product: