Manual Eagle FishEasy ST Fishfinder (page 8 of 40) (English)

469143

Zoom out

Zoom in

1/40

5. Remove the transducer from the bracket and re-assemble it with the

cable passing through the bracket over the bolt as shown above. At-

tach the transducer to the transom. Slide the transducer up or down

until it’s aligned properly on the transom as shown above. Tighten the

bracket’s mounting screws. Adjust the transducer so that it’s parallel to

the ground and tighten the lock nut until it touches the flat washer, then

add 1/4 turn.

Don’t over tighten the lock nut!

If you do, the transducer

won’t “kick-up” if it strikes an object in the water.

6. Route the transducer cable to the sonar unit. Make certain to leave

some slack inthe cable at the transducer as shown above. If possible,

route the transducer cable away from other wiring on the boat. Electri-

cal noise from the engine’s wiring, bilge pumps, VHF radio wires and

cables, and aerators can be picked up by the sonar. Use caution when

routing the transducer cable around these wires.

IMPORTANT!

Clamp the transducer cable to the transom close to the transducer. This

can prevent the transducer from entering the boat if it is knocked off at

high speed.

7. Make a test run to determine the results. If the bottom is lost at high

speed, or if noise appears on the display, try sliding the transducer

bracket down. This puts the transducer deeper into the water, hope-

fully below the turbulence causing the noise. Don't allow the trans-

ducer bracket to go below the bottom of the hull!

Bottom of Hull

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Eagle FishEasy ST Fishfinder in the language / languages: English as an attachment in your email.

The manual is 0,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Eagle FishEasy ST Fishfinder Manual

Product: