558523

E-bench KH 2074 Manual

51
Zoom out
Zoom in
Previous page
1/56
Next page
50
51
Note: Outside, the transmission range of the camera is up to 100 metres, inside
buildings it depends to a great extent on the construction materials used.
Tip: If your television set only has one SCART connection and you would like to
operate other devices with it besides your new eBench surveillance camera (video
recorder, DVD player etc.), you can connect the receiver of your surveillance camera
system between video recorder or DVD player and television set. To do this, connect
the receiver SCART-cable to the television set and the video recorder or DVD player
to the receiver per SCART-cable. When the receiver is switched on, the signal of
the camera will be received, interrupting the signal of the video recorder or DVD
player. When the receiver is switched off, the television set will receive the AV
signal again.
Once you have connected all the components together, camera and receiver must
now be set to the same channel.
Channel selection on the camera
Remove the rubber cover from over the channel selection switch on the back of the
camera. Choose the required channel by sliding the switch. Then replace the cover.
Channel and interval selection on the receiver
Choose the required channel by sliding the required switch to ON on the back of
the device (see Figure
).
The receiver receives signals from up to four cameras. If you have selected channel 1
for the rst camera, you must select channels 2-4 respectively for the other cameras.
If several cameras are in operation, you can use the “T” switch on the back of
the receiver to change the interval at which the receiver changes channels (4 or 8
seconds), i.e. changes between the images of the individual cameras.
A red LED on the front of the receiver ashes to show which channels are set. If
channel 1 is selected, the LED ashes once — depending on the set interval every four
or eight seconds. If channels 1 and 2 are set, the LED ashes once and then after
four or eight seconds twice etc..
Setting the image focus
Turn the lens protector (see Figure
) as far as it will go anticlockwise and remove
it. Then turn the focus ring to the right or left until the image is sharp. Now replace
the lens protector by placing it back on the lens and turning it to the right.
… 51 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for E-bench KH 2074 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of E-bench KH 2074 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,85 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info