702454
4
Zoom out
Zoom in
Previous page
1/7
Next page
click
IMPORTANT!
WASH FILTER 1
Wash filter with cold water at least every month.
Cleaning
6
7
USING YOUR DYSON APPLIANCE
PLEASE READ THE ‘IMPORTANT SAFETY INSTRUCTIONS’ IN THIS DYSON
OPERATING MANUAL BEFORE PROCEEDING.
CARRYING THE APPLIANCE
Carry the appliance by the main handle on the body.
Do not press the cyclone release button or shake the appliance when carrying,
or the cyclone could disengage, fall off and cause injury.
OPERATION
Always extend the cable fully to the red tape before use.
Plug the appliance into the mains electricity supply.
To switch ‘ON’ or ‘OFF’ press the power button, located as shown.
After use, unplug the appliance, retract the cable safely, and put the
appliance away.
Switch ‘OFF’ the appliance and unplug before:
– Adjusting the setting.
– Changing or using tools.
– Removing the hose or airway inspection parts.
To watch a short online video visit: UK – www.dyson.co.uk/DC39gettingstarted
ROI – www.dyson.ie/DC39gettingstarted
BRUSH BAR
The brush bar will always default to ‘ON’ (spinning) each time you switch the
appliance ‘ON.
To switch the brush bar off (e.g. for hard floors)
– Switch the machine ‘ON.
– Press the brush bar ‘ON/OFF’ button – the brush bar will stop spinning.
The brush bar will automatically stop if it becomes obstructed. See ‘Brush bar –
clearing obstructions’ on pages 4 and 7.
Before vacuuming your flooring, rugs and carpets, check the manufacturer’s
recommended cleaning instructions.
Some carpets may fuzz if a rotating brush bar is used when vacuuming.
If this happens, we recommend vacuuming in ‘hard floor’ mode and
consulting with the flooring manufacturer.
The brush bar on the appliance may damage some carpet types. If you are
unsure, turn ‘OFF’ the brush bar.
LOOKING AFTER YOUR DYSON APPLIANCE
Do not carry out any maintenance or repair work other than that shown in this
Dyson Operating Manual, or advised by the Dyson Helpline.
Only use parts recommended by Dyson. If you do not this could invalidate
your guarantee.
Store the appliance indoors. Do not use or store it below 0°C (32°F). Ensure the
appliance is at room temperature before operating.
Clean the appliance only with a dry cloth. Do not use any lubricants, cleaning
agents, polishes or air fresheners on any part of the appliance.
If used in a garage, always wipe the base plate and ball with a dry cloth
after vacuuming to clean off any sand, dirt, or pebbles that could damage
delicate floors.
VACUUMING
CAUTION:
Do not use without the clear bin and filter in place.
Fine dust such as plaster dust or flour should only be vacuumed in very
small amounts.
Do not use the appliance to pick up sharp hard objects, small toys, pins, paper
clips, etc. They may damage the appliance.
When vacuuming, certain carpets may generate small static charges in the
clear bin or wand. These are harmless and are not associated with the mains
electricity supply. To minimise any effect from this, do not put your hand or
insert any object into the clear bin unless you have first emptied it and rinsed it
out with cold water (see ‘Cleaning the clear bin’).
Powerful suction can cause the hose to ‘pull back’ – please take care.
Do not work with the appliance above you on the stairs.
Do not put the appliance on chairs, tables, etc.
Before vacuuming highly polished floors, such as wood or lino, first check that
the underside of the floor tool and its brushes are free from foreign objects that
could cause marking.
Do not push hard with the floor tool when vacuuming, as this may cause damage.
Do not leave the cleaner head in one place on delicate floors.
On waxed floors the movement of the cleaner head may create an uneven
lustre. If this happens, wipe with a damp cloth, polish the area with wax, and
wait for it to dry.
EMPTYING THE CLEAR BIN
Empty as soon as the dirt reaches the level of the MAX mark – do not overfill.
Switch ‘OFF’ and unplug before emptying the clear bin.
To remove the cyclone and clear bin unit, push the release button to the side of
the carrying handle, as shown.
To release the dirt, press the red bin release button.
To minimise dust/allergen contact when emptying, encase the clear bin tightly in
a plastic bag and empty.
Remove the clear bin carefully.
Seal the bag tightly, dispose as normal.
The British Allergy Foundation is a UK national charity with the aim of improving
awareness, prevention and treatment of allergies. The British Allergy Foundation
Seal of Approval is a UK registered trademark.
CLEANING THE CLEAR BIN
Remove the cyclone and clear bin (instructions above).
To separate the cyclone unit from the clear bin press the red bin release button
to open the bin base. This exposes a small silver button behind the red opening
mechanism. Press the silver button and separate the cyclone unit from the
clear bin.
Clean the clear bin with cold water only.
Ensure the clear bin is completely dry before replacing.
Do not use detergents, polishes or air fresheners to clean the clear bin.
Do not put the clear bin in a dishwasher.
Do not immerse the whole cyclone unit in water or pour water into it.
Clean the cyclone shroud with a dry cloth or dry brush to remove lint and dust.
WASHING YOUR FILTER
Your appliance has one washable filter, located as shown.
Check and wash the filter regularly according to instructions to
maintain performance.
Switch ‘OFF’ and unplug before checking or removing the filter.
The filter may require more frequent washing if vacuuming fine dust.
Wash the filter with cold water only. Do not use detergents. Hold under a tap
and run water through the open end for 10 seconds. Turn upside down and tap
out 10 times.
Squeeze and twist with both hands to make sure the excess water is removed.
Run water over the outside of the filter for 15 seconds.
Squeeze and twist with both hands to make sure the excess water is removed.
Place the filter on its side to dry. Leave to dry completely for 24 hours.
Do not put the filter in a dishwasher, washing machine, tumble dryer, oven,
microwave or near a naked flame.
IMPORTANT: After washing please leave at least 24 hours to dry completely
before refitting.
To watch a short online video visit: UK – www.dyson.co.uk/DC39filterwash
ROI – www.dyson.ie/DC39filterwash
LOOKING FOR BLOCKAGES
Switch ‘OFF’ and unplug before looking for blockages. Failure to do so could
result in personal injury.
Beware of sharp objects when checking for blockages.
Refit all parts securely before using.
Clearing blockages is not covered by your guarantee.
To access the flexible inspection hose beneath the clear bin, first remove the
clear bin (see above).
Unscrew the two Phillips screws on the clear bin locator bracket. (Do not remove
any other screws.) Remove the bracket.
Firmly twist the top of the flexible inspection hose away from the inlet next to the
ball (do not remove the end next to the connection for the main hose).
Inspect for blockages.
Reassemble in reverse order.
CLEARING BLOCKAGES – THERMAL CUT-OUT
This appliance is fitted with an automatically resetting thermal cut-out.
Large items may block the tools or wand inlet. If any part becomes blocked the
appliance may overheat and automatically cut-out.
Switch ‘OFF’ and unplug. Leave to cool down for 1-2 hours before the checking
the filter or for blockages. Do not operate the wand release catch.
Clear any blockage before restarting.
1
2
3
BRUSH BAR – CLEARING OBSTRUCTIONS
If your brush bar is obstructed, it may shut ‘OFF. If this happens you will need to
remove the brush bar as shown.
Switch ‘OFF’ and unplug before proceeding. Failure to do so could result in
personal injury.
Remove the brush bar by using a coin to loosen the fastener marked with a
padlock.
Beware of sharp objects when clearing obstructions.
Replace the brush bar and secure it by tightening the fastener. Ensure it is fixed
firmly before operating.
Clearing brush bar obstructions is not covered by your guarantee.
BRUSH BAR – TROUBLESHOOTING
If the brush bar has stopped spinning, follow the instructions above on clearing
obstructions. Alternatively, contact a Dyson expert on the Dyson Helpline or visit
the website.
DISPOSAL INFORMATION
Dyson products are made from high grade recyclable materials. Please dispose
of this product responsibly and recycle where possible.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson DC39 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson DC39 in the language / languages: English as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info