761154

Dyson Big Ball 2 Manual

17
Zoom out
Zoom in
Previous page
1/43
Next page
32 33
Cleaning the clear bin (optional)
In the event that it is necessary to clean the clear bin:
• Remove the cyclone and clear bin (see ‘Emptying the clear bin’).
• Open the bin base fully (see 'Emptying the clear bin').
• To separate the cyclone from the clear bin, pull the silver catch
behind the red bin release button and slide the clear bin off the
spine on the cyclone.
• Please refer to 'Emptying the clear bin and optional bin removal'
illustrations for additional bin removal and replacing guidance.
• Clean the clear bin with a damp cloth only.
• Do not use detergents, polishes or air fresheners to clean the
clear bin.
• Do not put the clear bin in a dishwasher.
• Do not immerse the cyclone in water or pour water into
the cyclones.
• Ensure the clear bin is completely dry before replacing.
• To refit the clear bin:
– Insert the spine into the bin runner
– Push upwards until it clicks and then continue pushing until it
slides home.
• Close the clear bin by pushing the bin base upwards. Ensure that
the bin base clicks and the clip is securely in place.
Washing your filter
• Your appliance has one washable filter, located as shown.
• Check and wash the filter regularly according to instructions to
maintain performance.
• Switch ‘OFF’ and unplug before checking or removing the filter.
• The filter may require more frequent washing if vacuuming
fine dust.
• Wash the filter with cold water only. Hold under a tap and run
water through the open end until the water runs clear. Turn upside
down and tap out.
• Run water over the outside of the filter for 15 seconds.
• Squeeze and twist with both hands to make sure the excess water
is removed.
• Do not put the filter in a dishwasher, washing machine, tumble
dryer, oven, microwave or near a naked flame.
• IMPORTANT: After washing please leave at least 24 hours to dry
completely before refitting.
Looking after your
Dyson appliance
• Do not carry out any maintenance or repair work other than
that shown in this Dyson Operating Manual, or advised by the
Dyson Helpline.
• Only use parts recommended by Dyson. If you do not this could
invalidate your guarantee.
• Store the appliance indoors. Do not use or store it below
3°C (37.4°F). Ensure the appliance is at room temperature
before operating.
• Clean the appliance only with a dry cloth. Do not use any
lubricants, cleaning agents, polishes or air fresheners on any part
of the appliance.
• If used in a garage, always wipe the base of the floor tool and base
of the appliance with a dry cloth after vacuuming to clean off any
sand, dirt or pebbles that could damage delicate floors.
Disposal information
• Dyson products are made from high grade recyclable materials.
Recycle where possible.
• This marking indicates that this product should not be disposed
with other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable
reuse of material resources. To return your used device, please
use the return and collection systems or contact the retailer
where the product was purchased. They can take this product for
environmentally safe recycling.
Online support
• For online help, general tips, videos and useful information
about Dyson.
UK - www.dyson.co.uk/support
ROI - www.dyson.ie/support
Product information
Please note: Small details may vary from those shown.
Compatibility with previous Dyson tools and accessories
• Your new machine comes with the latest Dyson technology. As
such it is equipped with the latest Quick release catches that allow
quick and easy tool or accessory changes. However, this makes it
incompatible with previous generations of Dyson products.
• An adaptor which makes your new machine compatible with older
Dyson tools and accessories is available by contacting your local
Dyson helpline (see ‘Dyson Customer Care’ section for contact
details).
• Availability varies from country to country.
Guarantee terms and conditions
Dyson customer care
Thank you for choosing to buy a Dyson appliance.
After registering your 5year guarantee, your Dyson appliance
will be covered for parts and labour for 5years from the date of
purchase, subject to the terms of the guarantee. If you have any
queries regarding your Dyson appliance, visit www.dyson.co.uk/
support (UK) or www.dyson.ie/support (ROI) for online help,
general tips and useful information about Dyson.
Alternatively, you can call the Dyson Helpline with your serial
number and details of where/when you bought the appliance.
If your Dyson appliance needs a repair, call the Dyson Helpline so
we can discuss the available options. If your Dyson appliance is
under guarantee, and the repair is covered, it will be repaired at
no cost.
Please register as a Dyson
appliance owner
To help us ensure you receive prompt and efficient service, please
register as a Dyson appliance owner. There are two ways to do this:
• Online at:
www.dyson.com/register
• Telephone the Dyson Helpline.
This will confirm ownership of your Dyson appliance in the event of
an insurance loss, and enable us to contact you if necessary.
Limited 5 year guarantee
Terms and conditions of the Dyson 5 year limited guarantee
What is covered
• The repair or replacement of your Dyson machine (at Dyson’s
discretion) if it is found to be defective due to faulty materials,
workmanship or function within 5 years of purchase or delivery (if
any part is no longer available or out of manufacture Dyson will
replace it with a functional replacement part).
• Where this machine is sold outside of the EU, this warranty will only
be valid if the appliance is used in the country in which it was sold.
EN
Using your Dyson appliance
Please read the ‘Important Safety Instructions’ in this Dyson
operating manual before proceeding.
Carrying the appliance
• Carry the appliance by the main handle.
• Do not press the cyclone release button or shake the appliance
when carrying or the cyclone could disengage, fall off and
cause injury.
Operation
• Always extend the cable fully to the red tape before use.
• Plug the appliance into the mains electricity supply.
• To switch ‘ON’ or ‘OFF’ press the red power button, located
as shown.
• After use: Unplug, push the cable retract button firmly until cable
has fully retracted.
• Switch 'OFF' the appliance and unplug before:
– Changing tools.
– Removing the hose.
Self-adjusting cleaner head with
suction control
• Your appliance has a self-adjusting cleaner head with suction
control. This cleaner head is used for testing with the European
Regulations: No. 665/2013 and No. 666/2013 and testing shall be
performed in Max mode (+).
Easy mode (-)
Reduced push force for effortless cleaning.
• For vacuuming of lightly soiled carpets, rugs and hard flooring.
• Your appliance is pre-set to this level of suction when you take it out
of the box.
Max mode (+)
Maximum suction for powerful dust and dirt removal.
• For vacuuming durable floor coverings, hard floors and heavily
soiled carpets and rugs.
• To switch to this setting, move the suction control slider on top of
the cleaner head as shown.
• CAUTION: The suction of this mode can damage delicate
flooring. Before vacuuming, check the flooring manufacturer’s
cleaning recommendations.
• If the suction power of Max mode (+) prevents easy
manoeuverability, switch to Easy mode (-).
Vacuuming
• Do not use without the clear bin and cyclone in place.
• Do not use on rubble, ash or plaster. This appliance is designed
only for domestic use to remove household dirt, hair and allergens.
The appliance is not designed to be used on:
– debris produced from activities such as DIY, building or
similar tasks
– larger types and quantities of dust or debris, such as soot
and sawdust.
These materials may harm the appliance and may void
your guarantee.
• Fine dirt such as flour should only be vacuumed in very
small amounts.
• Do not use the appliance to pick up sharp hard objects, small toys,
pins, paper clips, etc. They may damage the appliance.
• When vacuuming, certain carpets may generate small static
charges in the clear bin or wand. These are harmless and are
not associated with the mains electricity supply. To minimize any
effect from this small static charge, do not put your hand or insert
any object into the clear bin unless you have emptied it first, then
cleaned it with a damp cloth (see ‘Cleaning the clear bin’).
• Do not work with the appliance above you on the stairs.
• Do not put the appliance on chairs, tables, etc.
• Before vacuuming highly polished floors, such as wood or lino, first
check that the underside of the floor tool and its brushes are free
from foreign objects that could cause marking.
• Do not push hard with the floor tool when vacuuming, as this may
cause damage.
Blockages – thermal cut-out
• This appliance is fitted with an automatically resetting thermal
cut-out.
• If any part becomes blocked the appliance may overheat and
automatically cut-out.
• If this happens, follow the instructions in ‘Looking for blockages’.
• NOTE: Large items may block the tools or wand inlet. If this
happens, do not operate the wand release catch. Switch ‘OFF’ and
unplug. Failure to do so could result in personal injury.
Looking for blockages
• Switch ‘OFF’ and unplug before looking for blockages. Failure to
do so could result in personal injury.
• Leave to cool down for 1-2 hours before looking for blockages.
• Beware of sharp objects when checking for blockages.
• Clear any blockage before restarting.
• Refit all parts securely before using.
• Please refer to 'Looking for blockages' illustrations or 'Online
support' section for additional guidance.
• Clearing blockages is not covered by your guarantee.
Emptying the clear bin
• Empty as soon as the dirt reaches the level of the MAX mark – do
not overfill.
• Switch ‘OFF’ and unplug before emptying the clear bin.
• To remove the cyclone and clear bin unit, push the red button on
the top of the carrying handle, as shown.
• To release the dirt, firmly push the red bin release button.
– The bin will slide down, cleaning the shroud as it goes.
– The bin base will then open.
• The bin base will not open if the red button is not pushed
down fully.
• To minimise dust/allergen contact when emptying, encase the clear
bin tightly in a plastic bag and empty.
• Remove the clear bin carefully from the bag.
• Seal the bag tightly, dispose as normal.
• Close the clear bin by pushing the bin base upwards until it clicks
into place.
• Push the bin base clip firmly until it clicks into position to ensure that
the base is securely sealed.
• Align the base of the clear bin with the air hose inlet and then click
back into place.
1
3
2
… 17 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dyson Big Ball 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dyson Big Ball 2 in the language / languages: All languages as an attachment in your email.

The manual is 6,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info