667483
53
Zoom out
Zoom in
Previous page
1/62
Next page
48
XTL
500
User Guide
Cleaning the Cutter Blade
Clean the cutter blade each time you
replace the label cartridge.
To clean the cutter blade
1 Press the label compartment
release and lift the cover.
2 Remove the label cartridge.
3 Pinch the release lever on the
outside of the cutter blade and
pull the cutter blade straight up to
remove. See Figure 13.
.
4 Place the cutter blade on a flat surface
with the blade side facing up. See
Figure 14.
5 Use a cotton swab and alcohol to
clean both sides of the blade.
The cutter blade is extremely sharp.
Use caution when cleaning.
6 After cleaning the blade, insert the
cutter mechanism back into the label
maker and press into place.
Cleaning the Sensors
Several sensors inside the label
compartment need periodic cleaning to
remove dust and other particles that
may have accumulated.
To clean the sensors
1 Press the label compartment
release and lift the cover.
2 Remove the label cartridge.
3 Remove the cleaning tool from
inside the label compartment
cover.
4 Use the sponge end of the cleaning tool to gently wipe the sensors using an
up and down motion (not side to side). See Figure 15 for sensor locations.
Figure 13
Pinch and
pull up
Cutter
blades
Figure 14
Sensors
Figure 15
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dymo XTL500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dymo XTL500 in the language / languages: English as an attachment in your email.

The manual is 12,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dymo XTL500

Dymo XTL500 Quick start guide - English - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info