667484
12
Zoom out
Zoom in
Previous page
1/16
Next page
12
Punching Holes in Non-Adhesive Labels
You can choose to punch one or two holes in non-adhesive labels so
that the labels can be attached using screws, nails, rivets, and metal
or plastic wires or ties. You can also punch a cable tie slot in one or
both ends of the label.
To punch a hole
1. Insert one end of the cut label into the hole punch slot (L).
2. Lift the cutting handle (I) to the vertical position to punch a hole.
To punch a cable tie slot
1. Insert one end of the cut label into the cable tie slot (K) with the
letters facing down. The letters must face down to ensure the
bridge of the slot is on the same side of the label as the
characters.
Make sure to allow enough room for the tie-buckle before
and/or after the letters. A cable tie slot positioned on top of the
characters or a punched hole may cause the tape to jam.
2. Lift the cutting handle (I) to the vertical position to punch the slot.
L
K
I
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dymo Rhino M1011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dymo Rhino M1011 in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Dymo Rhino M1011

Dymo Rhino M1011 User Manual - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info