570778

Dymo LabelWriter SE300 Manual

115
Zoom out
Zoom in
Previous page
1/132
Next page
C-111
Appendix C
Printer Configuration Menu
The LabelWriter SE300 printer has a Printer Configuration Menu
built into its firmware. Through this menu, NVRAM (Non-
Volatile RAM) settings such as baud rate and feed distance can
be changed. NVRAM settings remain in effect even after power
has been removed from the printer.
The Printer Configuration Menu is accessible by using any
terminal communications (modem) program (i.e. Hyperterminal
in Windows) and communicating with the LabelWriter through
an RS-232 serial port. The communications software MUST be
configured to operate at 9600 baud with the communications
settings defined as no parity, 8 data bits, and 1 stop bit.
To access the Printer Configuration Menu, do the following:
1. Turn off the LabelWriter.
2. Press and hold down the form feed button.
3. While the form feed button is pressed, turn the printer on.
4. Continue to hold the feed button down for five more
seconds. The green light will blink. Release the feed
button.
5. Start your communications software. Press <Enter> until
the menu appears. Press ? for help.
… 115 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dymo LabelWriter SE300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dymo LabelWriter SE300 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info