570778

Dymo LabelWriter SE300 Manual

36
Zoom out
Zoom in
Previous page
1/132
Next page
4-32
SYN EL Mode Graphics
DESCRIPTION
Provided for LabelWriter EL compatibility.
SYN is a synchronization character used to encode EL bitmap
print data. The number of bytes in each string is controlled by the
ESC D command. The starting position (left margin) is controlled
by the ESC B command. The control electronics in the printer do
not check the validity of the bitmap data, therefore, it is the
responsibility of the host software to send the correct number of
data bytes for the width of the print head in use by the printer.
The print head forms the image by heating a row of resistive
elements that blacken the thermally sensitive label material. The
resistive elements are 0.125 millimeters square (0.00492 inches)
and are spaced at eight dots per millimeter (203.2 dots per inch)
apart. The print head on the LabelWriter SE300 contain 448
elements. When a line is to be printed, the control electronics in
the printer load the desired data into a serial shift register (the
print head). The serial shift register has one location for each
print element. A “1” in any given location causes the
corresponding dot to be printed; a “0” leaves the dot un-printed.
The most significant bit (bit 7) prints at the left margin.
There is no command for clearing the shift register, therefore, the
entire register must be loaded for each print line in order to flush
out the old data. To reset the LabelWriter after a synchronization
error or to recover from an unknown state, the host computer
should send at least fifty-seven (57) ESC characters, followed by
an A, to request the printer to return the status byte. A minimum
of 57 ESC characters are required because this amount exceeds
the longest possible string of bitmap data bytes that the
LabelWriter expects.
SEE ALSO
ESC B
ESC D
ETB
EXPRESSION
ASCII SYN d1…dn
Decimal 22 d1…dn
Hex 16 d1…dn
PARAMETERS
… 36 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dymo LabelWriter SE300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dymo LabelWriter SE300 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info