Manual Duux DXMA05 Blizzard (page 8 of 53) (English, German, Dutch, French, Spanish)

773952

Zoom out

Zoom in

1/53

1514

The unit will shut down automatically when

NIGHT mode is running for more than 12

hours.

Note: the night mode is not available while the

machine is operating in AUTO, Fan (ventilation) or

Dehumidication mode.

Note: In night mode, the display will

automatically dim after a few seconds. Press any

key to reactive the control panel.

Self-diagnosis

This machine is equipped with self-diagnosis

software. If the device is not working, the LCD

display will show “E1” or “E2”. When this occurs,

please contact your point of purchase.

All the above functions can also be performed with

the supplied remote control. This remote control

requires a cell battery CR2032 to operate.

Note:

•To prolong the lifespan of the compressor, please

wait at least 3 minutes before re-switching on the

device after switching o.

• The cooling system will switch o if the ambient

temperature is lower than the set one. However, the

ventilation keeps operating on the set level. If the

ambient temperature rises above the selected level,

the cooling will return to work.

Adjusting the ventilation speed

Press the SPEED button to choose the

ventilation speed you prefer: high, medium

or low. The indicator of high, medium or low

ventilation will illuminate.

Setting the timer

By pressing the TIMER button without using the

other functions, you can activate a start delay.

For example, if you set the timer to ‘2’, the unit

will automatically start after 2 hours.

Press the TIMER button to set a time-out (1 to

24 hours, the timer indicator will illuminate).

When the set time has been reached, the

machine will turn o automatically. The LCD

display will show the hour(s) you set as you

press the TIMER button.

Night mode

When pressing the NIGHT mode button in

cooling mode, the set temperature will increase

with 1⁰C after one hour, another 1⁰C after two

hours and then stays at that temperature.

In NIGHT mode, the ventilation will remain

at low speed. By pressing the NIGHT mode

button again, the temperature and ventilation

speed will return to the previous settings.

Drainage

During the process of cooling, some water will be

extracted from the air into the unit. If the reservoir

is full, both of the compressor and motor will

switch o and the units will buzz (press any button

to turn it o). The WATER FULL indicator will ash

to show you.In this case, please empty the water by

following the steps below:

Turn o the air conditioner and avoid moving it

when the water tank is full.

Put a container (a water tray for example)

underneath the drain hole.

Remove the drain knob & rubber plug from the

drain hole and allow the water to drain out.

When the container is almost full, close the

drain hole with the rubber plug and empty the

water tray.

Repeat until the unit is fully empty.

Replace the rubber plug andrmly tighten the

drain knob.

Switch on the device - the full water indicator

should not be ashing anymore.

If you wish to operate the unit without the need to

empty the water tank (continuous drainage), please

follow these steps:

• Remove the drain knob and rubber plug and

retain for future use.

• Connect the drain tube supplied to the water

outlet as shown and locate the other end into a

drain.

• The drain tube may be extended by adding an

extension tube and using a suitable connector.

Note:

• The drain must be at or below the outlet level.

• The FULL WATER indicator will be disabled in this

mode of drainage.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Duux DXMA05 Blizzard in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 9.66 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Duux DXMA05 Blizzard Manual

Product: