650115
7
Zoom out
Zoom in
Previous page
1/36
Next page
12 13
Normative references Notes
Guidanceandmanufacturer’sdeclaration–electromagneticemissions
Emissions Test Compliance
Group 1
Class B
Class A
Complies
Electromagnetic environment – guidance
The“Daylight”isintendedforuseintheelectromagneticenvironmentspeciedbelow.The
customer or the user of the “Daylight” should ensure that it is used in such an environment.
The “Daylight” uses RF energy only for its
internal function. Therefore, its RF emissions
are very low and are not likely to cause any
interference in nearby electronic equipment.
The “Daylight” is suitable for use in all
establishments, including domestic
establishments and those directly connected
to the public low-voltage power supply
network that supplies buildings used for
domestic purposes.
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltageuctuations/
ickeremissions
IEC 61000-3-3
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.2 1.2 2.3
10 3.8 3.8 7.3
100 12 12 23
Recommended separation distances between portable and mobile RF communications equipment and the Medical Daylight
Separation distance according to frequency of transmitter
The “Daylight” is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the Medical Daylight can help prevent electromagnetic interference by maintaining a
minimum distance between portable and mobile RF communications equipment (transmitters) and the “Daylight” as
recommended below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
W
150 kHz to 80 MHz 80 MHz to 800 MHz
800 MHz to 2,5 GHz
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using
the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to
the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected byabsorptionandreectionfromstructures,
objects and people.
Please read these instructions for use carefully and keep them for later use,
be sure to make them accessible to other users and observe the information
they contain.
Safety notes
Warning
- Do not use in humid surroundings.
- Before use, ensure that all packaging materials are removed and that there
is no visible damage to the unit or accessories. When in doubt, do not use the
unit and contact your dealer or the customer service address provided.
- The “Daylight” is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the
“Daylight.
- Keepthecordawayfromhotobjectsandopenames.
- Themandatoryminimumdistancebetweenthe“Daylight”andammable
objects is 1.0 meter.
- Connect the unit only to the mains voltage listed on the type plate.
- Always remove the mains plug and let the unit cool off before you touch it.
- Do not touch the unit with wet hands while it is plugged in; do not allow any
water to be sprayed onto the unit. The unit must be operated only when it is
completely dry.
- Protect the unit from strong impacts.
- Avoid pulling the cord when removing the plug from the socket. Instead, hold
the plug.
- If the cord or the housing is damaged, contact customer service or the
dealer, since special tools are needed to make repairs. Never try to repair the
appliance yourself.
- Disconnection from the mains supply is only guaranteed if the mains plug
has been removed from the socket; do not position the daylight so that it is
difculttooperatetheplugdevice.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Duronic SADV1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Duronic SADV1 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info