621588
21
Zoom out
Zoom in
Previous page
1/33
Next page
not start
(continued
from page
19)
Spark plug is broken. Replace spark plug.
Generator is not on level
surface.
Move generator to a level surface to
prevent low oil shutdown from
triggering.
Oil is low Add or replace oil.
Engine
runs but
there is no
electrical
output
Circuit breaker is off.
Set the circuit breaker to the “ON”
position.
Bad connecting wires/cables.
If you are using an extension cord,
try a different one.
Bad electrical device
connected to generator.
Try connecting a different device.
Generator
runs but
does not
support all
electrical
devices
connected.
Generator is overloaded
Try connecting fewer electrical loads
to the generator.
Shorten one of the connected
devices.
Try disconnecting any faulty or
short-circuited electrical loads.
Air cleaner is dirty. Clean or replace air cleaner.
GENERATOR ASSEMBLY AND MOUNTING
Generator is supplied with a wheel kit. If you want to install the wheel kit on your unit, please
follow the instructions below. If you will not be using the wheel kit, skip this section.
1. Place the bottom of the generator cradle on a flat, even surface. Temporarily place
unit on blocks to ease assembly.
2. Secure the support leg to the cradle with cap screws (M8 x 16) and lock nuts (M8)
(see figure 22 ).
3. Secure the axle to the cradle with cap screws (M8 x 16) and lock nuts (M8) (see figure
23).
Figure 22 Figure 23 Figure 24
4. Slide a wheel over the axle, then secure the wheel with a retaining pin.
(see figure 24,Figure 25, Figure 26).
5. Position the handles on the cradle and attach, cap screws (M8 x 16) and lock nuts (M8)
( Figure 27,Figure 28).
6. Check that all fasteners are tight.
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Duromax XP4400E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Duromax XP4400E in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info