613248
13
Zoom out
Zoom in
Previous page
1/102
Next page
2. Operation
2.1 Removal and Placement of the Clamp Plates
Caution Risk of Injury !
Pull the mains plug.
Remove or place the clamp plates only with the machine
turned off.
The removal or placement of the clamp plates 3 and 5 occurs in the machine end
position (see Chapter 2.3).
The clamp operating lever 1 must be open !
This is the case when it is pushed to the back until it hits.
ATTENTION !
In order to avoid damage to the needle the combined
finger-eye protection 4 must remain swung down.
Sub-class -231391 and -251301:
Removing the clamp plates
Swing the clamp plate holder 2 away to the side.
Reach under each nail slit 6 and lift the clamp plate.
Remove the clamp plates to the front.
Placing the clamp plates
The clamp operators 8 must reach into the forks of the clamp arms.
Push the clamp plates to the right or left against the pressure screws 7 and plate
edges 9.
Place the clamp plates over the setbolt 10 on the material support plate.
Swing the clamp plates holder 2 back over the clamp plates.
The clamp plates are secured against lifting.
Check by closing the clamp operating lever 1 if the clamps open and close correctly.
15
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 558 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 558 in the language / languages: English as an attachment in your email.

The manual is 6,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 558

Durkopp Adler 558 User Manual - German - 102 pages

Durkopp Adler 558 User Manual - French - 102 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info