613281
36
Zoom out
Zoom in
Previous page
1/51
Next page
3.2 Mounting of table top with integrated drive on machine head
Turn the table top (1) upper side down.
Screw the drawer (2) on.
Set the oil tray (3) so that the oil tray inside aligns with the recess
in the table top and screw it on.
Screw the microswitch (4) on.
Screw the motor control box (5) on.
Screw the set value sensor (6) on.
Screw the lighting transformer (7a) on - the lighting Waldmann,
(7b) - the lighting 2-LEDs.
Screw the cable canal (8) on.
Mount the electric cables according to section 5 of these
Instructions and fix them to the table top with clamps.
Screw the stand frame to the table top - pre-drilled holes (9).
Then turn the stand to the normal position.
Mount the yarn stand (10) according to the picture, insert it into the
hole in the table top and fix it with a nut with washer.
Fix the support blinds (11).
Stick rubber hinge bottoms (12) and rubber corners (13) with a
suitable contact glue. Stick horizontal fitting surfaces of the hinge
bottoms only. You can also fix the hinge bottoms by means of wood
screws which must be then screwed down so deep so that there is
no contact of the wood screws and the machine head.
5
EN
30
490
640
15
120
390
15
9 8 4 5 6 3 7a 9 1 2
430
500
246
355
380
10
13
11
12
165
10
7b
160
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 524i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 524i in the language / languages: English as an attachment in your email.

The manual is 1,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 524i

Durkopp Adler 524i User Manual - German - 51 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info