6.2 Nadelfadenspannung einstellen
Vorspannung
Bei geöffneter Hauptspannung 4 und Zusatzspannung 5 (z.B. bei
gelüfteten Nähfüßen) ist eine geringe Restspannung des Nadelfadens
erforderlich. Die Restspannung wird durch die Vorspannung 2 erzeugt.
Die Vorspannung 2 beeinflusst gleichzeitig die Länge des
geschnittenen Nadelfadenendes (Anfangsfaden für die nächste Naht).
–
Grundeinstellung:
Rändelmutter 2 verdrehen, bis ihre Vorderseite mit Bolzen 1
bündig steht.
–
Kürzerer Anfangsfaden:
Rändelmutter 2 im Uhrzeigersinn drehen.
–
Längerer Anfangsfaden:
Rändelmutter 2 gegen den Uhrzeigersinn drehen.
Hauptspannung
Die Hauptspannung 4 ist so gering wie möglich einzustellen.
Die Verschlingung der Fäden soll in der Mitte des Nähgutes liegen.
Zu starke Fadenspannungen können bei dünnem Nähgut zu
unerwünschtem Kräuseln und Fadenreißen führen.
–
Hauptspannung 4 so einstellen, dass ein gleichmäßiges Stichbild
erreicht wird.
Spannung erhöhen - Rändelmutter im Uhrzeigersinn drehen
Spannung verringern - Rändelmutter gegen den Uhrzeigersinn
drehen
Zusatzspannung
Die zuschaltbare Zusatzspannung 5 dient zur schnellen Änderung der
Nadelfadenspannung, z. B. an Nahtverdickungen.
–
Zusatzspannung 5 niedriger als Hauptspannung 4 einstellen.
–
Zusatzspannung 5 mit Hebel 3 z u- bzw. abschalten.
Hebel 3 nach links = Zusatzspannung ist ausgeschaltet.
Hebel 3 nach rechts = Zusatzspannung ist zugeschaltet.
6.3 Nadelfadenspannung öffnen
Unterklasse -170010; -180010
Beim Lüften der Nähfüße w erden Haupt- und Zusatzspannung auto-
matisch geöffnet.
Unterklasse -170115; -180115
Die Nadelfadenspannung wird beim Fadenabschneiden automatisch
geöffnet.
Hinweis !
(nur für Unterklasse -170115; -180115)
Der Zeitpunkt der Fadenspannungslüftung kann mit den Parametern
F-191 und F-192 (Techniker-Ebene) eingestellt werden.
11