633977
72
Zoom out
Zoom in
Previous page
1/82
Next page
2.5.2 Presser foot lift head S52
Caution: Risk of injury!
Switch the main switch off.
Check and adjust the presser foot lift only with the sewing unit
switched off.
Standard
When the piston rod 1 is extended, the lever 4 should abut on screw 6
and the clearance under the sewing feet should amount to 5 mm.
Furthermore there should be a distance of 0.3 mm between stop 11
and screw 10 in this position.
Correction
Loosen counternut 5 and screw the screw 6 down completely.
Swivel the sewing foot in.
Turn handwheel in direction of rotation until the teeth of the
feed-dog are underneath the top edge of the throat plate.
Loosen screw 2 and press ring 3 backwards as far as it will go.
Tighten screw 2 in this position.
Take care that ring 3 and lever 4 have no axial backlash.
Press lever 7 down until there is a distance of approx. 5 mm
between sewing foot and throat plate.
Let screw 6 abut on lever 4 in this position and fix it by a locknut.
Note
If lever 4 does not abut on screw 6 when the piston rod 1 of the
cylinder is extended, please proceed as follows:
Loosen nut 8.
Shift cylinder 1 correspondingly.
Tighten nut 8.
Loosen screw 9.
Turn screw 10 in such a way that there is a distance of approx. 0.3
mm between screw 10 and stop 11.
Take care that lever 7 is pressed down as far as it will go.
Tighten screw 9.
14
6
11
9
5
1
2
3
4
7
1
8
10
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Durkopp Adler 1225-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Durkopp Adler 1225-5 in the language / languages: English as an attachment in your email.

The manual is 2,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Durkopp Adler 1225-5

Durkopp Adler 1225-5 User Manual - German - 82 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info