Manual DT Swiss L3 Remote Lever (page 11 of 21) (English, German, French)

780261

Zoom out

Zoom in

1/21

L2 / L3 Remote Lever 11

4. ASSEMBLY

4.1 INSTALLING THE L2 REMOTE LEVER

NOTE: The L2 remote lever is compatible with the

Matchmaker X interface. This allows the remote lever to

be attached directly to the clamp of a Sram brake lever

without a clamp.

1. Dismount the grip from the handlebar, open the

screw of the clamp slightly and slide the clamp onto

the left side of the handlebar.

2. Position the remote lever in such a way that the

lever can be comfortably reached with the thumb

and neither impairs its own function nor interferes

with the function of other control elements.

3. Tighten the xing screw with a Torx T25 key with a

torque of max. 1.5 Nm.

→ If the remote lever is tted on carbon handlebars, the maximum torque may be lower.

Observe the handlebar manufacturer’s user manual!

4.2 INSTALLING THE CABLE AND CABLE HOUSING ON THE L2 REMOTE LEVER

1. Move the remote lever to the starting position (see picture).

2. Attach the cable housing and the cable adjuster.

→Only cable housings with an outer diameter of 4.2 mm

must be used.

→Before and after the cable adjuster there must be

at least one short piece of cable housing.

→Screw in the cable adjuster completely and

then loosen one turn.

3. Shorten the cable housing to the desired

length.

4. Put the shift cable through the

remote lever.

5. Attach the cable to the component to be operated

and shorten it if necessary.

For more information, refer to the user manual

or the technical manual of the corresponding

component.

6. Check the function and readjust the cable if

necessary.

7. Repeat the above steps as necessary to assemble

a second cable.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of DT Swiss L3 Remote Lever in the language / languages: English, German, French as an attachment in your email.

The manual is 1.15 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

DT Swiss L3 Remote Lever Manual

Product: