810233
47
Zoom out
Zoom in
Previous page
1/56
Next page
If the main burner DOES continue to burn:11. Clean the glass pane before using it for the first time, as described in the user manual. Then mount the glass pane as described in chapter 8.12. Repeat the ignition procedure a few times and perform the checks described in section 10.3.2.13. From now on, the main burner should ignite smoothly and continue to burn.14. Clean the glass pane after burning for the first time, as described in the user manual.3Always wait 5 minutes before re-igniting the appliance.10.3.2 Procedure for igniting the main burner3-The ignition electrode should ignite the main burner(s) within a couple of seconds and without popping.-The main burner(s) must pass over fluently without popping, covering the entire burner, and continue to burn.-If the appliance does not ignite after 2 restarts and enters hard lockout, it may never be reset by disconnecting the appliance from the power supply. If a restart is necessary after all: remove or open the glass pane and make sure the gas is able to escape from the appliance. After this, the appliance may be disconnected from the power supply for 10 sec. After these 10 sec., the power supply may be reconnected.Ignite the appliance in the same way as the first ignition, as indicated in section 10.3.1.1Check operation of the main burner from a cold condition.1If sparks are determined between the ignition electrodes, the main burner should burn within a few seconds.3If NO sparks are determined, it is NOT permitted to continue the procedure.Consult the diagram with error messages (appendix 1: (Malfunctions) if the ignition of the main burner does not comply with the above-mentioned requirements.2The flame picture and a good flame transfer can only be properly judged if the glass pane is installed or closed.10.4 Flame pictureThe flame picture can only really be assessed when the appliance has been burning for several hours. Volatile components from paint, materials, etc., which evaporate in the first hours, will affect the flame image.1Check that the flame picture is in order.1Consult the diagram with error messages (appendix 1: Malfunctions) if the flame picture is not in order.Installation manual47
47


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DRU Maestro 60 RCH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DRU Maestro 60 RCH in the language / languages: English as an attachment in your email.

The manual is 4.91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DRU Maestro 60 RCH

DRU Maestro 60 RCH User Manual - German - 56 pages

DRU Maestro 60 RCH User Manual - Dutch - 28 pages

DRU Maestro 60 RCH Installation Guide - Dutch - 56 pages

DRU Maestro 60 RCH User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info