571711
40
Zoom out
Zoom in
Previous page
1/64
Next page
38
INSTALLATION MANUAL
Check the wiring of thermocouple 2 for:
- Loose wiring;
- Wrongly connected wiring;
- Short-circuit;
- Broken wire.
Check if thermocouple 2 is dirty.
Check if thermocouple 2 is positioned correctly in the
ame; see fi g. 18.
Check if thermocouple 2 is defective; see chapter 11,
table 4 under J7.
Check if the receiver is defective; see chapter 11, table 4
under J8.
If necessary, correct the above mentioned faults.
Test the main burner 5x for a good operation.
8.4 Flame image
The fl ame image can only really be assessed when the ap-
pliance has been burning for several hours. Volatile compo-
nents from paint, materials, etc., which evaporate in the fi rst
hours, will affect the fl ame image.
!Caution If the chimney breast is made of stone-
like materials or has a plaster fi nish, this
may only take place 6 weeks after placing
the chimney breast, in order to prevent
shrinkage cracks.
Check whether the fl ame image is acceptable.
If the fl ame image is not acceptable, this can be due to:
- the evaporation of volatile substances;
- incorrect placement of the wood set;
- incorrect settings of the appliance.
If necessary, improve the placement of the wood set.
If necessary, improve the settings of the appliance; for this,
see section 6.8.
9. Maintenance
Once a year the appliance should be checked, cleaned and,
if necessary, repaired by a competent installer in the fi eld of
atmospheric gas-fi red heating.
Check at least whether the appliance is working properly
and safely.
- Close the gas tap when performing
maintenance work;
- Check the gastightness after repair;
- After replacing thermocouple 1 you
should fi rst tighten the swivel by hand and
then give it another quarter turn with a
suitable spanner;
- Do not turn the pilot burner lower by
using the settings on the gas control.
If required, clean the following components:
- the pilot burner;
- the space surrounding the pilot burner;
- thermocouple 2;
- the pane.
!Tip - Use the service hatches to remove ther-
mocouple 2 (see Fig. 19).
!Caution - Remove/place the pane as described in
section 6.10;
- Remove the deposit on the inside of the
pane with a damp cloth or a non-abrasive
detergent such as copper polish;
- Avoid/remove fi ngerprints on the pane,
since otherwise they will burn into the
surface;
- Replace a broken and/or cracked pane, as
described in section 6.10.
If necessary, place back the wood set cor-
rectly; for this, see section 6.9.
Inspect the fl ue gas discharge / combustion air supply
system.
You must always perform a fi nal check.
• Perform a check as described in chapter 8.
9.1 Parts
Parts that must be replaced, can be obtained from your
supplier.
10. Delivery
You must explain to the user how he should operate the
appliance. You should instruct her/him for instance on using
the appliance for the fi rst time, the operation of the remote
control, annual maintenance.
- Tell the user to close the gas tap immedi-
ately in case of malfunctions/bad perfor-
mance and contact the installer in order
to prevent dangerous situations;
- Indicate the location of the gas tap;
- Point out the precautions in the user
manual concerning unintended ignition by
other remote controls such as car keys
and garage door openers.
Instruct the user about the appliance and the remote
control.
When the appliance is started for the fi rst time, point out
that
- in order to avoid cracks in a chimney breast made of
stone-like materials or fi nished with plaster, it should dry
for at least 6 weeks prior to putting the appliance into
operation
- when the appliance is stoked up for the fi rst time, volatile
components evaporate from paint, materials, etc.;
- when evaporating, the appliance should preferably be set
at the highest level;
- the room should be well ventilated.
Give this booklet containing the manuals to the user
(the booklet should be kept near the appliance).
Caution
Caution
Caution
Caution
40


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DRU GLOBAL 100 BF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DRU GLOBAL 100 BF in the language / languages: Dutch as an attachment in your email.

The manual is 2,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of DRU GLOBAL 100 BF

DRU GLOBAL 100 BF User Manual - English - 20 pages

DRU GLOBAL 100 BF User Manual - German - 20 pages

DRU GLOBAL 100 BF User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info