Manual Drive Flame 3 - model HS925 (page 22 of 28) (English)

811658

Zoom out

Zoom in

1/28

Instruction Booklet

User should inspect the tires frequently for damage, the presence of foreign bodies, unusual

wear and sufficient tread depth. If replacement tires are needed, please contact the nearest

dealer.

Front and rear wheel : Ø 370 x 90 mm (15”) air tire.

The following areas require periodic inspection :

•Tire pressure between 30-35 psi

•Tread depth drops below 0.5 mm

Recommended range of storage,

Temperature : -30°c ~ +50°c, Humidity : 25% ~ 85%

Follow these easy steps to replace the tire :

1.Turn off the scooter and remove the key. Make sure

the lever is in D position before you lift the scooter.

2.Use an ratchet and socket to remove the drive

wheel screw from the centre hub of the wheel. Pull the wheel off of the axle.

3.Separate the tire from the rim.

4.Remove the old tire and replace it with a new tire.

5.Slide the wheel back onto the shaft.

6.Install the drive wheel nut into the centre hub and verify the key is lined up with axle

and wheel,then tighten to secure it in place. (Torque 300 ± 30kgf - cm)

All maintenance and repair of scooter should be done by an authorized dealer.

Tire :

Component 5 is for rear wheel only

•Do not use any abrasive or scouring liquids for cleaning. Only use a damp cloth and

gentle detergent.

•Do not use hose pipe or splash water directly onto the scooter as this may cause damage

to electronics.

7-4 CLEANING YOUR SCOOTER

•User should inspect the scooter regularly to keep scooter in good running order.

•Check if the electrical cable connectors are fully connected.

•All maintenance and repair of scooter should be done by an authorized dealer.

7-5 MAINTENANCE

Only use damp cloth and a little soap to wipe the seat. Do not use abrasive cleaners as

this will damage the seat.

Seat Upholstery :

•

The frame and shroud of the scooter can be wiped with lightly damp cloth. Do not use

abrasive cleaners as this will damage the coating.

•

Car polish can be used to keep the paint and frame in pristine condition.

Frame / Shroud :

•Please store the scooter in a dry location. If store the scooter in long time, please

disconnect the battery terminals.

•Do not store your scooter where it will be exposed to source of direct heat, damp, oil,

acid, alkaline, or where Ozone could be possibly generated. All of the above will minimize

scooter / tire cycle and shorten its lifetime.

Storage :

Flame 3 (model HS925)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Drive Flame 3 - model HS925 in the language / languages: English as an attachment in your email.

The manual is 4.06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Drive Flame 3 - model HS925 Manual

Product: