488609
15
Zoom out
Zoom in
Previous page
1/93
Next page
15
GB
DREMEL TOOL SAFETY
Read and save this instruction manual and the enclosed safety instructions
When you put away the tool, switch off the motor and ensure that all moving parts have come to a complete
standstill
In case of electrical or mechanical malfunction, immediately switch off the tool or disconnect charger
Only use the original DREMEL accessories which can be obtained from your DREMEL dealer.
Before using accessories always compare the maximum allowed r.p.m. of that specific accessory with the
r.p.m. of the tool
This tool should not be used by people under the age of 16 years
Never use grinding wheels over 1 1/4” (32 mm) Ø
Never use drill bits over 1/8” (3.2 mm) Ø
Never use shaft lock while tool is running
Store tool in locations where temperature will not exceed 40°C
Ensure that the collet size corresponds with the shaft size of the accessory
Keep the air vent openings clean and uncovered
Handle and store grinding/cutting discs carefully to avoid chipping and cracking
Do not use damaged, deformed or vibrating grinding/cutting discs
For mounting/using non-Dremel accessories observe the instructions of the manufacturer concerned
Before using the tool
• ensure that accessory is correctly mounted and firmly tightened
• check if accessory runs freely by turning it by hand
• test-run tool for at least 30 seconds at highest no-load speed in a safe position
• stop immediately in case of considerable vibration or other defects and check tool to determine the cause
! Never use a cutting disc for side grinding
When grinding metal, sparks are generated; keep other persons and combustible material from work area
Wear protective glasses and gloves, hearing protection, a dust mask, and sturdy shoes; when necessary also
wear an apron
Apply wire of bristle brush lightly to the work as only the tips of the wire/bristles do the work.
! The accessory continues to rotate for a short time after the tool has been switched off
DREMEL CORDLESS TOOL SAFETY
A battery operated tool with a separate battery pack must be recharged only with the specified charger for the
battery.
Use battery operated tool only with the specifically designated battery pack. Use of any other batteries may
create a risk of fire.
Avoid accidental starting. Be sure switch is in the off position before inserting the battery pack.
Disconnect battery pack from tool or place the switch in the off position before making any adjustments,
changing accessories, or storing the tool.
When the battery pack is not in use, keep it away from other metal objects like: paper clips, coins, keys, nails,
screws, or other small metal objects that can make a connection from one terminal to another.
Always hold the tool firmly in your hands during the start-up.
BA
TTERY / CHARGER SAFETY
Before using the battery charger, read all instructions and cautionary markings on the 786 battery charger,
785 battery pack, and 780 product using battery.
Use only the charger which accompanied your product or direct replacement as listed in the catalog or this
manual.
Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or otherwise
damaged in any way.
Do not recharge battery in damp or wet environment. Do not expose charger to rain or snow. If battery case
is cracked or otherwise damaged, do not insert into charger.
Charge only Dremel No. 785 rechargeable batteries with charger 786.
Charge battery pack in temperatures above 0°C and below 40°C. Store tool and battery pack in locations
where temperatures will not exceed 40°C or drop below 0°C .
When damaged and under extreme usage and temperature conditions, batteries in battery pack may start to
leak. If liquid comes into contact with the skin, wash quickly with soap and water, then with lemon juice or
vinegar. If liquid gets into eyes, flush eyes with clean water for a minimum of 10 minutes and seek immediate
medical attention.
Place charger on flat, non-flammable surfaces and away from flammable materials when recharging battery
pack.
780manual cordless_3 06.11.2001 11:18 Uhr Seite 15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dremel 780 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dremel 780 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info