Manual Dremel 1680 (page 14 of 64) (English, French, Spanish)

32309

Zoom out

Zoom in

1/64

14.

Basic Scroll Saw Operations

Making Interior Scroll Cuts

(Pin-End Blades and Plain-End Blades)

TO AVOID ACCIDENTAL STARTING,

ALWAYS TURN SWITCH “OFF” AND

REMOVE PLUG FROM POWER SOURCE BEFORE

REMOVING OR REPLACING THE BLADE.

A main benefit of this saw is the ability to perform intricate

interior cuts quickly and easily. This is best accomplished

using the Quick Release Tension Lever. Simply follow these

steps (Fig. 12):

1. Drill appropriate sized pilot hole in work piece.

2. Release Quick Release Tension Lever.

3 Remove the blade from the upper blade holder as explained

on page 12 Removing and Installing (Pin-End) or (Plain-End)

blades.

4. Thread blade through pilot hole from underneath the work-

piece. If needed, remove the table insert. This will allow the

blade to fall forward for more clearance between the workpiece

and the upper arm housing. Reinstall the blade in the upper

blade holder.

5. Retension blade by pulling tension lever down.

6. Lower drop foot until it just rests on top of the workpiece and

you’re ready to begin cutting.

7. When finished making the interior scroll cuts simply remove

the blade from the blade holders, as described on page 12

Removing and Installing (Pin-End) or (Plain-End) blades, and

remove the board from the table.

WARNING

FIG. 12

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dremel 1680 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dremel 1680 Manual

Product: