768201
35
Zoom out
Zoom in
Previous page
1/48
Next page
8.0 MAINTENANCE
R699780 - Starlight User Manual 35
Tighten the screws of the lamp unit.
Attach the lamp cover and fasten the two lamp trap screws.
Resetting Lamp Time
After installing a new lamp, reset the lamp time into the OSD menu.
a) Insert plug into the power outlet
b) When the projector is in standby mode (red STANDBY/ON led), use the remote control and press sequentially
the [BACK] - [OK] - [HIDE] within 1 second interval then [DOWN] for at least 2 seconds.
c) The sequence is successful if the STANDBY/ON and LAMP leds blink alternately for 3 seconds.
8.4 Cleaning and Replacing the Dust Filters
The filters must be cleaned regularly to allow an efficient air intake. Otherwise, dirt may enter the unit and
appear on the screen, preventing you from enjoying the video fully. If dirt has entered the unit or if you need
information about the filter, please consult your authorized dealer. A filter cleaning warning appears every
500 hours.
Pull out the plug from the power outlet
Pull out the power plug from the outlet while the projector is in standby mode.
Remove the filters
Push up and lift the claw of the filters, pull out the filters.
Clean the filters
Clean the filters with water and dry them, avoiding direct sunlight. In extremely soiled cases, use of a neutral
detergent is recommended.
Reinstall the filters
Insert the filters in their original positions and make sure that the claws are firmly inserted.
Clean the Dust Filters every 500 hours.
8.5 Troubleshooting
TO ENSURE THE LAMP TIME HAS BEEN RESET
The lamp time can be checked via the Lamp hours item of the Information menu.
CAUTION DURING RESET WORK
Reset the lamp time only when you have replaced the lamp.
Never reset it when the lamp is still in use. Otherwise, the approximate standard for gauging replacement time may
be inaccurate, lamp performance may deteriorate and lamp blowout may occur.
Dust Filters
35


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DreamVision Star Light at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DreamVision Star Light in the language / languages: English as an attachment in your email.

The manual is 3,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info