653292
14
Zoom out
Zoom in
Previous page
1/24
Next page
User Guide Digistat+RF Room Thermostat
Changing the Minimum Temperature Setting
1.
To adjust the “Preset” temperature enter the User
menu by pressing and holding the Set button for
more than 5 but less than 10 seconds. The display
will show ‘Pr’.
2.
Rotate the dial clockwise until Lo is showing.
3.
Then press the Set button, the current setting is
shown.
4.
Rotate the dial clockwise to increase the minimum
temperature setting and anti-clockwise to reduce
the minimum temperature setting (min. 5°C) as
shown.
5.
Press the Set button to conrm, the display will
show Lo.
NOTE:
When adjusting the settings within the menu, if the
maximum or minimum possible setting are reached,
the display will ash to indicate you cannot adjust the
product further, e.g. you cannot set the temperature
lower than the minimum temperature setting.
To return to normal operation, either press the Set
button for more than 5 seconds or wait for 1 minute
and it will return automatically.
Tamper Proong
To tamper proof the product i.e. prevent unauthorised
adjustment of the product, set the Min. and Max. (HI and
Lo) temperatures to the same desired value using the
procedures above.
Fault Diagnosis
If the display shows E1, the following faults could have
occurred:
1.
Internal temperature sensor has failed. Replace
the unit,
2.
Ambient temperature is outside product operating
temperature range - 0°C to 50°C.
When the ambient temperature is back within the
operating range, the unit will function correctly.
Battery Replacement
When the batteries are getting low (approx. 30
days battery life remaining) the battery symbol will
ash in the display, it is recommended to change the
batteries during this period.
After approximately 30 days, a continuous battery
symbol only will be shown in the display and the unit
will remain OFF.
Remove the battery compartment by pinching the tabs
and withdrawing down. Replace the spent batteries
with 2 x AA 1.5V alkaline batteries ensuring correct
orientation. Replace the battery compartment pressing
fully home.
12 Installation & User Guide
06515085001 ISSB
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Drayton DIGISTAT plus RF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Drayton DIGISTAT plus RF in the language / languages: English as an attachment in your email.

The manual is 4,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info