499406

Dr. Kern Prestige Manual

26
Zoom out
Zoom in
Previous page
1/40
Next page
INSTALLATION GUIDE
The complete system is delivered on a pallet as
standard.
For transport of the system to its final location in the
cabin, it is necessary to disassemble the system partially
and to reassemble it at its destined position. (Notice:
Observe the following sequence of disassembly/
reassembly).
Also please ensure that both the transport route within
the studio as well as the final location within the cabin
are large enough to accommodate the system.
Recommended minimum cabin size 2.5 x 2.3 m
Please note that the electrical connection of the
system may be performed only by an approved
professional or certified electrician under observance
of the regulations of the VDE and the local power
supply utility.
Disassembly of the front base cover
Unscrew the threaded fasteners for the base panel on
both sides and remove the decorative caps.
Then pull the base cover forward and out.
Removal of the electrical plug-in module
All ballast units, compensators as well as the controls
for the system are integrated into an electrical plug-in
module, equipped with casters for mobility and located
below the bench.
Before you roll out the electrical plug-in module from
the front, you must place a provisional ramp in front of
the system at the same level as the transport pallet.
Now remove the transport locks of the electrical plug-
in module. Finally, the module under the bench is rolled
forward and out.
decorative
cap
threaded
fastener
front base cover
electrical unit
transport pallet
ramp
(provisional)
26 english
Now pull the electrical plugs of the canopy, the bench
and the rear side exhaust unit from the electrical plug-
in module.
… 26 …


Need help? Post your question in this forum.

Forumrules
1

Forum

dr.-kern-prestige

Reset search

  • I have a 2005 dr kern prestige tan bed, looking for used facial glass & u.v. Filters & possibly complete asm including retaining brackets Submitted on 9-12-2021 at 05:33

    Reply Report abuse

  • I have a 2005 dr kern prestige tan bed , looking for facial glass or complete u.v. Glass & retainer Submitted on 9-12-2021 at 05:18

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dr. Kern Prestige at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dr. Kern Prestige in the language / languages: English, German as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info