571252

Dovre TAI 45C Manual

51
Zoom out
Zoom in
Previous page
1/223
Next page
Be careful not to smother the fire by adding too
much coal at once.
You have added as much as you can when the
glow from the previous load is only just visible.
6. Close the door.
7. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
If the coal basket begins to glow red, the fire is
burning too strongly.
Burning coal with bunker
After you have followed the instructions for lighting:
1. Open the primary air slide (thermostat) all the way.
2. Slowly open the door of the appliance.
3. Spread the charcoal evenly across the bottom of
the stove base.
4. Close the door.
5. Slowly open the filling panel in the top plate.
09-20020-359
6. Fill the bunker with coal to below the rearmost air
openings in the bunker.
7. Close the filling lid.
8. Allow the coal to burn well for a few minutes and
then set the thermostat to the desired position.
The filling frequency depends on the output
demanded.
To keep the stove burning at night, the ther-
mostat is turned down to around position 1.
The correct position depends on the flue and
the weather conditions.
If the coal basket begins to glow red, the fire is
burning too strongly.
Heating recommendations
Never burn wood with an open door.
Regularly burn wood with intense roaring fires.
If you burn at a low setting frequently, tar and
creosote may be deposited in the flue. Tar and
creosote are highly combustible substances.
Thicker layers of these substances may catch
fire if the temperature in the flue increases sud-
denly. By allowing the fire to burn very
intensely regularly, layers of tar and creosote
will disappear.
Low intensity fires can also cause tar deposits
on the stove window and door.
When the outside temperature is mild, it is bet-
ter to burn wood intensely for a few hours
instead of having a low intensity fire for a long
period of time.
Regulate the air supply using the secondary air
inlet (only when burning wood).
The secondary air inlet not only supplies air to
the fire but to the glass as well, so that it does
not quickly become dirty.
Open the primary air inlet for the time being if the air
supply by the secondary air inlet is inadequate or if
you want to fan the fire.
Topping up with a few logs regularly is better than
adding many logs in one go.
Regularly adding small amounts of brown coal bri-
quettes or anthracite coal is better than adding a
large amount of brown coal briquettes or anthracite
coal in one go.
Extinguishing the fire
Do not add fuel and just let the fire go out. If a fire is
damped down by reducing the air supply, harmful sub-
stances will be released. For this reason, the fire
should be allowed to go out naturally. Keep an eye on
Subject to change because of technical improvements
19
… 51 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre TAI 45C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre TAI 45C in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 9,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info