Manual Dovre TAI 45C (page 44 of 223) (English, German, Dutch, French, Italian, Spanish)

571252

Zoom out

Zoom in

1/223

Safety

Please note: All safety regulations must be

complied with strictly.

Please read carefully the instructions supplied

with the appliance for installation, use and

maintenance before using the appliance.

The appliance must be installed in accordance

with the legislation and requirements applic-

able in your country.

All local regulations and the regulations relating

to national and European standards must be

observed when installing the appliance.

The appliance should preferably be installed by

an authorised installer. Installers will be aware

of the applicable regulations and requirements.

The appliance is designed for heating pur-

poses. All surfaces, including the glass and

connecting tube, can become very hot (over

100°C)! When operating, use a so-called "cold

hand" or an oven glove.

Ensure that there is adequate screening if

young children, disabled people, the elderly or

animals are present in the vicinity of the appli-

ance.

Safety distances from flammable materials

must be strictly adhered to.

Do not place any curtains, clothes, laundry or

other combustible materials on or near the appli-

ance.

When in use, do not use flammable or explos-

ive substances in the vicinity of the appliance.

Avoid chimney fires by having the chimney

swept regularly. Never burn wood with the door

open.

In the event of a chimney fire: close all the

appliance's air inlets and alert the fire service.

If the glass in the appliance is broken or

cracked, it must be replaced before you can

use the appliance again.

Ensure that there is adequate ventilation in the

room in which the appliance is installed. If vent-

ilation is insufficient, combustion will be

incomplete whereby in toxic gases can spread

through the room. See the chapter "Installation

requirements" for more information on vent-

ilation.

Installation

requirements

General

The appliance must be connected tightly to a well-

functioning flue.

For connection measurements: see "Technical

data" appendix.

Ask the fire service and/or your insurance com-

pany about any specific requirements and reg-

ulations.

Flue

The flue is needed for:

Removal of combustion gases via natural draught.

As the warm air in the flue or chimney is lighter

than the outside air, it rises.

Air intake, needed for the combustion of fuel in the

appliance.

A poorly-functioning flue or chimney can cause smoke

to escape into the room when the door is opened.

Damage caused by smoke emissions into the room is

not covered by the warranty.

Do not connect multiple appliances (such as a

boiler for central heating) to the same flue,

unless local or national regulations allow this.

In the event of two connections ensure that the

difference in height between the connections is

no less than 200 mm.

Ask your installer for advice regarding the flue. Refer

to the European norm EN13384 for a correct cal-

culations for the flue.

The flue must satisfy the following requirements:

The flue or chimney must be made of fire-resistant

material, preferably ceramics or stainless steel.

Subject to change because of technical improvements

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Dovre TAI 45C in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 9,71 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Dovre TAI 45C Manual

Product: