571245
50
Zoom out
Zoom in
Previous page
1/164
Next page
Appendix 4: Diagnostic diagram
Problem
Wood does not keep burning
Gives off insufficient heat
Smoke emissions into the room when adding wood
Fire in appliance is too intense, is hard to adjust
Deposit on the glass
Possible cause Possible solution
Insufficient draught
A cold flue usually fails to create sufficient draught. Follow the
instructions for lighting in the "Use" chapter; open a window.
Wood too damp Use wood with no more than 20% moisture.
Piecesof wood too big
Use smallpieces of kindling. Use split logsno larger than 30 cm in
circumference.
Wood stacked up incorrectly
Stackup the wood in a way that allows an adequate air flow between
the logs (open stacking, see "Burning wood")
Chimney does not work properly
Check whether the chimney meets the requirements: at least 4
metres high, right diameter, wellinsulated, smooth inside, not too
many bends, no obstructions in chimney (bird's nest, too much soot
deposit), hermeticallytight (no chinks).
Chimney stack incorrect Sufficientlyhigh above the roof, no obstaclesin its vicinity
Air inlets set incorrectly Open the air inlets completely.
Appliance connected to chimney
incorrectly
Connection should be hermeticallytight.
Vacuum in area where appliance is
installed
Switch off extraction systems.
Insufficient supply of fresh air
Provide an adequate air supply; if necessary use connection to
outside air.
Adverse weather conditions?
Inversion (reversed air flow in chimney
because of a high outside temperature),
extreme wind velocities
We recommend you don't use the appliance in the case of inversion.
Install an extra hood on the flue to increase the draught if need be.
Draught in the living room
Avoid draught in the living room, do not place the appliance near a
door or heating air ducts.
Flames touch the glass
Make sure the wood does not lie too close to the glass. Slide the
primary air inlet cover closer to the "Closed" position.
Appliance is leaking air Check the door sealsand the appliance joints.
24
Subject to change because of technicalimprovements
50


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre ASTRO 4CBWB LEON at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre ASTRO 4CBWB LEON in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 28,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info