571283

Dovre 300G Manual

33
Zoom out
Zoom in
Previous page
1/52
Next page
300G / 310GX 33 03.27635.000
4. Instructions for use
4.1. Fuel
The only suitable fuels for this stove are wood, brown coal briquettes and charcoal.
No other fuels are allowed to be burnt, as they can inflict serious damage to your
stove.
Do not burn any treated wood either, such as scrap wood, dyed wood, impregnated
or preserved wood, plywood or chipboard. The fumes of these, as of synthetic mate-
rials, old papers and household waste, are highly polluting for both your stove and
your chimney, and for the environment. They also could cause chimney fires.
Wood
Hard woods, such as oak, birch- and fruit-trees, are the ideal fuels for your stove.
The wood must have dried for at least two years in a covered and well-ventilated
place. Split logs will dry faster. Dry wood should contain no more than twenty per-
cent moisture.
Wet logs are unsuitable for burning, as they do not produce enough heat and all of
the energy is lost in the process of evaporation. Moreover, the burning of wet wood
causes badly smelling gases to be released and a thick layer of tar will deposit on
the stove panels and in the chimney.
Brown coal briquettes
Brown coal briquettes burn in more or less the same way as wood does. You should
only burn briquettes on a bed of charcoal in your stove.
Charcoal
There are several categories of anthracite coal. Some characteristics may be legally
determined. For instance anthracite “A” has to contain less than 10% of volatile sub-
stances, anthracite “B” less than 12%. The ash content may range from 3 to 13%.
For a good operation of your appliance, the use of anthracite “A” with a low ash con-
tent is recommended. A combustible with a high ash content has a lower net heating
value. Moreover, the ashes have to be removed more frequently and the fire will go
out faster. The recommended calibre is 12/22 or 20/30.
4.2. Lighting a fire
In order to create sufficient draught and to prevent smoke from being emitted into
the room, the chimney should be warm enough before lighting a fire. A cold chim-
ney can be heated up by lighting a ball of paper above the fire plate.
To kindle the fire in the stove you can use paper and/or firelighters and small pieces
of wood.
Slightly open the door and pull the air slides wide open. See the sketch on how to
use the air slides.
It is important that the kindled fire should burn intensely. You can then throw larger
pieces of wood onto the fire, and close the doors. When the fire has stabilized and is
glowing enough, you can put the logs, the charcoal or the brown coal briquettes on
the fire.
… 33 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre 300G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre 300G in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 2,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info