571602

Dovre 2510R Manual

57
Zoom out
Zoom in
Previous page
1/253
Next page
3. Close the base of the flue with incombustible
material.
4. Make a 150 cm diameter opening in the base for
the extraction duct.
5. Centre the opening in the base on the connection
collar on the stove.
6. Put the extraction duct in the opening. Make sure
that the duct can be pulled down so that it fits into
the connection collar. For example, use a variable-
length duct.
If you are using a RFS-flexible duct: screw the
duct onto the connector supplied, put the con-
nector into the connection collar and secure the
connector by bending the two lips outwards.
The figure below provides an example of the placing of
a fireplace insert in a hearth which is done using the
instructions given above.
A Existing hearth
B Ventilation space (minimum 15 mm)
C Existing flue
D Fireproof material or connector
E Opening to prevent pressure build-up
Building into a new hearth
The fireplace insert is installed in two stages:
Placing and connecting the fireplace
Building up the hearth around the fireplace.
Placing and connecting the fire-
place insert
1. Place the appliance at the right height and level it.
2. If you are going to put an external casing around
the appliance, you should fit the clamping plates
supplied to the sides of the appliance without fully
tightening the screws. This is because the outside
casing fits between the appliance and the clamp-
ing plates; see next figure.
3. Check that there is at least 15 mm of free con-
vection space between the existing walls - which
must have the necessary insulation (see chapter
"Installation Conditions”) - and the back of the
appliance.
4. The masonry should not rest on the fireplace. If
required, use a support such as a steel beam.
Leave a clearance of at least 3 mm between the
support and the appliance.
4. Connect the appliance to the flue hermetically.
5. Check the draught in the flue and the seal of the
connection on the flue gas duct by making a small,
Subject to change because of technical improvements
13
… 57 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre 2510R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre 2510R in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 21,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info