571269
25
Zoom out
Zoom in
Previous page
1/40
Next page
25OCB-250CBS 25 03.27630.000
4. Instructions for use
4.1. Fuel
The only suitable fuels for this stove are wood and for 250CB also brown coal bri-
quettes. No other fuels are allowed to be burnt, as they can inflict serious damage to
your stove.
Do not burn any treated wood either, such as scrap wood, dyed wood, impregnated
or preserved wood, plywood or chipboard. The fumes of these, as of synthetic mate-
rials, old papers and household waste, are highly polluting for both your stove and
your chimney, and for the environment. They also could cause chimney fires.
Wood
Hard woods, such as oak, birch- and fruit-trees, are the ideal fuels for your stove.
The wood must have dried for at least two years in a covered and well-ventilated
place. Split logs will dry faster. Dry wood should contain no more than twenty per-
cent moisture.
Wet logs are unsuitable for burning, as they do not produce enough heat and all of
the energy is lost in the process of evaporation. Moreover, the burning of wet wood
causes badly smelling gases to be released and a thick layer of tar will deposit on
the stove panels and in the chimney.
Brown coal briquettes (only for 250CB)
Brown coal briquettes burn in more or less the same way as wood does. You should
only burn briquettes on a bed of charcoal in your stove.
4.2. Lighting a fire
In order to create sufficient draught and to prevent smoke from being emitted into
the room, the chimney should be warm enough before lighting a fire. A cold chim-
ney can be heated up by lighting a ball of paper above the fire plate.
To kindle the fire in the stove you can use paper and/
or firelighters and small pieces of wood.
Slightly open the door and pull the air slides wide
open. See the sketch on how to use the air slides.
It is important that the kindled fire should burn in-
tensely. You can then throw larger pieces of wood
onto the fire, and close the doors. When the fire has
eventually stabilized and is glowing enough, you can
put the logs or the brown coal briquettes on the fire.
4.3. Burning wood
The best way to control the fire is to completely close
the lower air slide, which you use to get the fire start-
ed, and to regulate the air supply with the upper air
slide only. In case the air supply through the upper
slide seems insufficient, or if you would like to fan the
fire, you can partially open the lower air slide for a
while.
Always keep the stove doors tightly closed. Never let
the doors open when the fire is burning.
Add extra fuel when necessary. Never add too much fuel. It is best to fill the stove
1 : primary air
2 : secondary air
= open = close
1
2
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre 250CB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre 250CB in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info