571604

Dovre 2210C Manual

64
Zoom out
Zoom in
Previous page
1/253
Next page
Tar and creosote are highly combustible sub-
stances. Thicker layers of these substances
may catch fire if the temperature in the chim-
ney increases suddenly. By allowing the fire to
burn very intensely regularly, layers of tar and
creosote will disappear.
Low intensity fires also cause tar deposits on
the stove window and door.
When the outside temperature is not very low,
it is better to burn wood intensely for a few
hours instead of having a low intensity fire for a
long period of time.
Control the air supply with the secondary air inlet.
The secondary air inlet not only supplies air to
the fire but to the glass as well, so that it does
not quickly become dirty.
Open the primary air inlet for the time being if the air
supply by the secondary air inlet is inadequate or if
you want to fan the fire.
It is better to add a small amount of logs regularly
than to add many logs at the same time.
Regularly adding small amounts of brown coal bri-
quettes or anthracite coal is better than adding a
large amount of brown coal briquettes or anthracite
coal in one go.
Extinguishing the fire
Do not add fuel and just let the fire go out. If a fire is
damped down by reducing the air supply, harmful sub-
stances will be released. For this reason, the fire
should be allowed to go out naturally. Keep an eye on
the fire until it has gone out. All air inlets can be closed
once the fire has died completely.
Removing ash
After wood has burnt, a relatively small amount of ash
is left over. This ash bed is a good insulating layer for
the stove base plate and improves combustion. It is
good idea to leave a thin layer of ash on the stove
base plate.
After brown coal briquettes and anthracite coal have
burnt, a relatively large amount of ash is left over.
Remove the excess ash regularly.
The ash should never reach the bottom of the
grate. This will cause the grate to overheat and
be damaged.
The flow of air through the fire plate must not be
obstructed, and ash must not be allowed to accu-
mulate behind an inner plate. Remove the excess ash
regularly.
1. Open the door of the appliance.
2. Use the riddling rod to make the ash drop through
the grate into the ash pan.
3. Using the cold handle glove supplied, remove the
ash pan and empty it; see the next two figures.
4. Replace the ash pan and close the door of the
appliance.
Fog and mist
Fog and mist hinder the flow of flue gases through the
flue. Smoke can blow back and cause a stench. If it is
not strictly necessary, it is better not to use the stove
in foggy and misty weather.
Solving problems
Refer to the appendix "Diagnostic diagram" to resolve
any problems in using the stove.
20
Subject to change because of technical improvements
… 64 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dovre 2210C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dovre 2210C in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 21,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info