775776
49
Zoom out
Zoom in
Previous page
1/116
Next page
49
DO987BFK
www.domo-elektro.be
EN
· Avoid direct sunlight and heat. Direct sunlight may aect the acrylic
coating. Heat sources nearby will cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to
from very quickly on the evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the
voltage stated on the rating label of your appliance corresponds to the
voltage in your home. A dierent voltage could damage the appliance.
· The appliance must be grounded. The manufacturer is not responsible
for damages that may occur as a result of usage without grounding.
· After installation, leave the freezer for 8 hours before turning it on. This
way the refrigerant can settle.
· Allow the appliance to run empty for 24 hours so the compartment can
cool to the appropriate temperature.
· This appliance is designed to operate in ambient temperature between
16°C and 38°C. If these temperatures are exceeded, i.e. colder or
warmer, the appliance will not operate correctly.
· The appliance may only be used indoors.
· The freezer makes noise when the compressor pumps the coolant. This is normal.
DOOR CONVERSION
If you need to hinge your door on the opposite side it is recommended that you call your local authorised
service agent to make this conversion or ask a technician. Before you reverse the door, you should ensure
the appliance is unplugged and empty.
After reversing the door, leave the appliance alone for 8 hours before switching it on. This allows the
coolant to set. We recommend using a slotted screwdriver, a Phillips screwdriver, and a wrench (not
included), as well as the components supplied below.
Hinge cover plate
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
Top door stopper
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
Bottom door stopper
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
1. Loosen the screws of the hinge cover plate and remove the plate. Disconnect both connectors of the
cables.
,QVWDOODWLRQ

Door Reversibility


Left Aid-Closer on Upper Door x 1 Left Aid-Closer on Lower Door x 1
 nscrew top hinge cover and disconnect connectors of door switch and harness.
2.Unscrew top hinge
3.Remove the pin with a screwdriver and filp the hinge bracket. Then refit the pin to hinge bracket
unscrew
screw
8
13
y
y
,QVWDOODWLRQ
1007NN
1071NN
6SDFH5HTXLUHPHQW
Keep enough space of door open.
Keep at least 50mm gap at two sides.
To do this adjust the two levelling feet at front of the unit.
If the unit is not level, the doors and magnetic seal
alignments will not be covered properly.
/HYHOOLQJWKHXQLW
13
49


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Domo DO987BFK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Domo DO987BFK in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 19.26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info