610411
14
Zoom out
Zoom in
Previous page
1/328
Next page
EN
Installing the refrigerator RM122, RM123
14
7 Installing the refrigerator
7.1 Preparing the installation
Observe the following instructions when installing the refrigerator:
The refrigerator should not exceed an angle of inclination of 3° so that the
refrigerant can be circulated properly. Make make sure that the ice tray is
flat in the refrigerator when the vehicle is level.
The refrigerator must be installed in a recess so that it remains fixed in
place during movement of the vehicle. Mind the following dimensions:
(HxWxD in mm): 662x384x415.
All surfaces around exhaust pipe and burner housing must be of or cov-
ered by metal or other non-flammable material.
In the outer wall an air inlet (fig. 3 1, page 3) and vent hole (fig. 3 2,
page 3) with ventilation grid has to be provided so that emerging heat can
be properly dissipated to the outside:
air inlet: ventilation grid as flush as possible to the floor of the fitted
niche with a cross-section of at least 250 cm²
vent hole: preferably atop the device. Here a ventilation grid with inte-
grated exhaust gases duct can be used instead.
If the air inlet‘s ventilation grid cannot be mounted flush to the floor, an
additional air inlet (fig. 3 4, page 3) must be provided in the floor to dis-
charge leaking gas.
The air inlet and the vent hole must not be covered by vehicle compo-
nents (e.g. bumper or open door) during operation.
At the back of the refrigerator must be enough space so that air can
circulate around the cooling element.
Provide a heat conducting plate on the upside (fig. 3 1, page 3) so that
heat cannot build up inside the vehicle.
The refrigerator must be installed draught-proof according to EN 1949,
see chapter “Installing the refrigerator draught-proof” on page 15.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dometic RM123 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dometic RM123 in the language / languages: All languages as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info