18
INSTALLATION GUIDE
On installation of the appliance, the technical and administrative regulations of the
country in which the vehicle will first be used must be adhered to. Otherwise the
refrigerator must be installed as described in these instructions. In some OEM appli-
cations it may not be possible for these instructions to be followed exactly. In this case
an authorised Dometic representative may issue supplementary instruction.
Installation
The appliance and its fume extraction shall be installed in such a way as to be acces-
sible for servicing at all times and must be capable of easy removal and installation.
The appliance may only be installed by authorised personnel.
Installation and connection of the appliance must comply with the latest
technical regulations.
It must be installed in accordance with
the manufacturer's installation instructions,
local gas fitting regulations,
municipal building codes,
electrical wiring regulations,
AS 5601- Gas Installations
and any other statutory regulations.
The appliance shall be installed in such a way that it is shielded from
excessive heat radiation.
Excessive heat impairs performance and raises the energy consumption of the
refrigerator.
66..00
6.1
6.1.1
Any installation that is not carried out by authorized persons will jeo-
pardize the manufacturer's guarantee.
Air vent grille
not blocked: OK!
6.1.2
An installation that is not carried out by authorized persons causes a
reduction in the cooling capacity and will jeopardize the manufacturer's
guarantee.
If the refrigerator is mounted at the rear of
the vehicle you must ensure the lower gril-
le is not covered by the bumper or rear
lights. This would be prevent the air from
circulating properly and cause problems in
warm weather.
If the appliance is installed on the same
side of the vehicle as the entrance door, it
is desirable that the door does not cover
the refrigerator’s vents. If this cannot be
avoided there must be a gap of at least
25mm between the door and the vents.
Rear installation
Side installation